I have Opensuse 10.2 and I want my ATI Mach64 card to use 3D.
00:0c.0 VGA compatible controller: Trident Microsystems TGUI 9660/938x/968x (rev d3) (prog-if 00 [VGA])
Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 5
Region 0: Memory at e9000000 (32-bit, non-prefetchable) [disabled] [size=4M]
Region 1: Memory at e9400000 (32-bit, non-prefetchable) [disabled] [size=64K]
Expansion ROM at e8000000 [disabled] [size=64K]
01:00.0 VGA compatible controller: ATI Technologies Inc 3D Rage Pro AGP 1X/2X (rev 5c) (prog-if 00 [VGA])
Subsystem: ATI Technologies Inc Rage Pro Turbo AGP 2X
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping+ SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 32 (2000ns min), Cache Line Size: 32 bytes
Region 0: Memory at e4000000 (32-bit, non-prefetchable) [size=16M]
Region 1: I/O ports at e000 [size=256]
Region 2: Memory at e6000000 (32-bit, non-prefetchable) [size=4K]
[virtual] Expansion ROM at 30000000 [disabled] [size=128K]
Capabilities:  AGP version 1.0
Status: RQ=256 Iso- ArqSz=0 Cal=0 SBA+ ITACoh- GART64- HTrans- 64bit- FW- AGP3- Rate=x1,x2
Command: RQ=1 ArqSz=0 Cal=0 SBA- AGP- GART64- 64bit- FW- Rate=<none>
I have two cards, and the first on that list is a Trident card, which is from the Windows 95 era, and doesn't have 3D support at all. The only time I use it is when I want to screens to expand my desktop, and most of the time the card isn't activated as part of Xorg.
So, how do I get this Mach64 (aka. Rage Pro) working with 3D? Has anyone tried it?
For now my non-acclerated desktop works fine.
PIII @ 733 Mhz
512 MB Ram PC133