I am confused. I "maked" and make installed after adding the windows driver,
then did a system log and here is what I got: (part of it... it is soo long)
ndiswrapper version 1.0@050130 loaded (preempt=no,smp=no)
slamr: module license 'Smart Link Ltd.' taints kernel.
slamr: SmartLink AMRMO modem.
slamr: probe 8086:24c6 ICH4 card...
ACPI: PCI interrupt 0000:00:1f.6[B] -> GSI 7 (level, low) -> IRQ 7
PCI: Setting latency timer of device 0000:00:1f.6 to 64
slamr: mc97 codec is SIL21
slamr: slamr0 is ICH4 card.
[root@localhost ndiswrapper]# iwconfig
lo no wireless extensions.

eth0 no wireless extensions.

eth1 no wireless extensions.

sit0 no wireless extensions.

[root@localhost ndiswrapper]# iwlist wlan0 scan
wlan0 Interface doesn't support scanning.

[root@localhost ndiswrapper]# iwconfig wlan0 essid ESSID
Error for wireless request "Set ESSID" (8B1A) :
SET failed on device wlan0 ; No such device.

Can anyone help?

thanks ip

This is how I got my Linksys WPC11 Ver. 4 card to work, it may help you.

Hope it helps!

Wireless & ndiswrapper

Did you modprobe? It will not automatically perform a modprobe on boot so you may need to do it again. BTW, you only need to make install, no make is required unless things have changed since ndiswrapper 0.12RC3
Regards
Chris

Yes I did modprobe. I don't know what is going on with it. I would love to get either my modem or wireless working since rebooting between experiments eats 10 minutes.
thanks for your help

regards