Hi Guys,
I am running Kubuntu 5.10 and I am following this guide here:
https://wiki.ubuntu.com/Linksys_WUSB11
I did everything exactly except that I ran KDE and not GNOME.
Right now the driver got installed, when I plugged in the adapter the GUI responded and the driver get loaded. Under the KDE System Settings I can see the connection wlan0 but I can't enable it. When I toggle it on it would turn off on its own in a second.
Please tell me what information should I provide to solve the problem.
Thank you.
ifconfig
Code:
eth0 Link encap:Ethernet HWaddr 00:0F:EA:79:8E:7F
inet addr:192.168.1.11 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::20f:eaff:fe79:8e7f/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1605 errors:0 dropped:0 overruns:0 frame:0
TX packets:1491 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1572068 (1.4 MiB) TX bytes:186240 (181.8 KiB)
Interrupt:21 Base address:0xe000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:56 errors:0 dropped:0 overruns:0 frame:0
TX packets:56 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:3747 (3.6 KiB) TX bytes:3747 (3.6 KiB)
/etc/network/interfaces
Code:
# The loopback network interface
auto lo
iface lo inet loopback
address 127.0.0.1
netmask 255.0.0.0
# This is a list of hotpluggable network interfaces.
# They will be activated automatically by the hotplug subsystem.
mapping hotplug
script grep
map eth0
# The primary network interface
#iface eth0 inet dhcp
iface eth0 inet static
address 192.168.1.11
netmask 255.255.255.0
gateway 192.168.1.1
broadcast 192.168.1.255
iface wlan0 inet dhcp
wireless-essid
wireless-key ******************************
auto wlan0
