I just installed the ivtv driver for my tv tuner but when I use it with kdetv ,it freezes, I tried AleTV, MoTV, XAWTV, and Zapping but all of them just give me a blank screen.
Specs: SuSe 10.1 / HP m7470n / PVR 150 MCE
<4>ivtv: module not supported by Novell, setting U taint flag.
<6>ivtv: ==================== START INIT IVTV ====================
<6>ivtv: version 0.6.3 (tagged release) loading
<6>ivtv: Linux version: 2.6.16.13-4-bigsmp SMP 586 REGPARM gcc-4.1
<6>ivtv: In case of problems please include the debug info between
<6>ivtv: the START INIT IVTV and END INIT IVTV lines, along with
<6>ivtv: any module options, when mailing the ivtv-users mailinglist.
<6>ivtv0: Autodetected Hauppauge WinTV PVR-150 card (cx23416 based)
<6>ACPI: PCI Interrupt 0000:02:01.0[A] -> GSI 21 (level, low) -> IRQ 193
<6>tveeprom 0-0050: Hauppauge model 26552, rev F068, serial# 9305646
<6>tveeprom 0-0050: tuner model is LG TAPE H001F MK3 (idx 68, type 47)
<6>tveeprom 0-0050: TV standards NTSC(M) (eeprom 0x08)
<6>tveeprom 0-0050: audio processor is CX25843 (idx 37)
<6>tveeprom 0-0050: decoder processor is CX25843 (idx 30)
<6>tveeprom 0-0050: has radio, has no IR remote
<6>tuner 0-0061: chip found @ 0xc2 (ivtv i2c driver #0)
<6>tda9887 0-0043: chip found @ 0x86 (ivtv i2c driver #0)
<6>ACPI: PCI Interrupt 0000:00:13.2[A] -> GSI 19 (level, low) -> IRQ 201
<6>ehci_hcd 0000:00:13.2: EHCI Host Controller
<6>ehci_hcd 0000:00:13.2: new USB bus registered, assigned bus number 1
<6>ehci_hcd 0000:00:13.2: irq 201, io mem 0xfe02c000
<6>ehci_hcd 0000:00:13.2: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
<6>usb usb1: new device found, idVendor=0000, idProduct=0000
<6>usb usb1: new device strings: Mfr=3, Product=2, SerialNumber=1
<6>usb usb1: Product: EHCI Host Controller
<6>usb usb1: Manufacturer: Linux 2.6.16.13-4-bigsmp ehci_hcd
<6>usb usb1: SerialNumber: 0000:00:13.2
<6>usb usb1: configuration #1 chosen from 1 choice
<6>hub 1-0:1.0: USB hub found
<6>hub 1-0:1.0: 8 ports detected
<7>ieee1394: Initialized config rom entry `ip1394'
<7>ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI)
<6>cx25840 0-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #0)
<6>8139too Fast Ethernet driver 0.9.27
<6>Linux agpgart interface v0.101 (c) Dave Jones
<6>cx25840 0-0044: loaded v4l-cx25840.fw firmware (16382 bytes)
<6>wm8775 0-001b: chip found @ 0x36 (ivtv i2c driver #0)
<6>ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
<6>ivtv0: Encoder revision: 0x02050032
<6>ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total)
<6>ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total)
<6>ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total)
<6>ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total)
<6>ivtv0: Create encoder radio stream
<6>tuner 0-0061: type set to 47 (LG NTSC (TAPE series))
<6>ivtv0: Initialized Hauppauge WinTV PVR-150, card #0
<6>ivtv: ==================== END INIT IVTV ====================
