I just bought a WPC11 v.3 wireless card because I read somewhere that it was easy to configure in Fedora Core 2. Now, of course, I cannot find that article! Can't get it to work so far, but I have a feeling that I'm very close. When I first booted up with it in, the lights on the card were on. That was a good sign. However, when I open a browser, no connectivity. I ran iwconfig and came up with this:
lo no wireless extensions.
sit0 no wireless extensions.
eth0 no wireless extensions.
eth1 IEEE 802.11-DS ESSID:"" Nickname:"Prism I"
Mode:Managed Access Point: 00:00:00:00:00:00 Bit Rate:11Mb/s
Tx-Power=15 dBm Sensitivity:1/3
Retry min limit:8 RTS thr
ff Fragment thr
ff
Encryption key
ff
Power Management
ff
Link Quality:0/92 Signal level:-68 dBm Noise level:-122 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
It's listed here, and seems to ready to go, but I noticed there is no Access Point listed. Does anyone know where I go from here? I have no idea what to do next! Thanks in advance!
