Hi all,
Well, so heres the story. I installed mandrake 10.0 recently and i have a dlink dwl-520. So I used ndiswrapper 0.11 along with rtl8180 v1.5. Followed all the directions and everything went fine. I was able to set the essid using iwconfig and get an IP address from the router. I then setup ip masq on it. Everything is going great, working like a charm. So now I figure, i'd like to move my box someplace else so it doesn't take up any space on my desk. I move it about 3 feet away from its original location and power it back up. It no longer has an ip address and isn't connected to any AP. I try doing iwconfig wlan0 essid "ap" but it still displays "ESSID
ff/any". I cannot seem to get the card to connect to any AP anymore and I know signal strength is fine because its all in the same room.
What would cause iwconfig to no be able to set the essid on the card? I also tried setting the mode to managed and that still doens't work. Any other suggestions on what I should check?
Thanks,
Toan