Hi, Thanks for your response. I must say I didn't know where to look. Here is tail output from the log. I have included messages in the log that seem suspect also. Does the system core dump when it hangs?
=====================================================================
ACPI: RTC can wake from S4
system 00:00: iomem range 0x0-0x9ffff could not be reserved
system 00:00: iomem range 0xc0000-0xc3fff could not be reserved
system 00:00: iomem range 0xc4000-0xc7fff could not be reserved
system 00:00: iomem range 0xc8000-0xcbfff has been reserved
system 00:00: iomem range 0xcc000-0xcffff has been reserved
===================================================================
sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
sda: sda1 sda2
===================================================================
CONFIG_NF_CT_ACCT is deprecated and will be removed soon. Plase use
nf_conntrack.acct=1 kernel paramater, acct=1 nf_conntrack module option or
sysctl net.netfilter.nf_conntrack_acct=1 to enable it.
===================================================================
Freeing unused kernel memory: 412k freed
Write protecting the kernel text: 2744k
Write protecting the kernel read-only data: 1172k
Clocksource tsc unstable (delta = -454949379 ns)
Synaptics Touchpad, model: 1, fw: 7.0, id: 0x1c0b1, caps: 0xd04791/0xb00000
serio: Synaptics pass-through port at isa0060/serio1/input0
input: SynPS/2 Synaptics TouchPad as /devices/platform/i8042/serio1/input/input5
EXT3-fs: INFO: recovery required on readonly filesystem.
EXT3-fs: write access will be enabled during recovery.
psmouse serio2: ID: 10 00 64<6>IBM TrackPoint firmware: 0x0e, buttons: 3/3
input: TPPS/2 IBM TrackPoint as /devices/platform/i8042/serio1/serio2/input/input6
kjournald starting. Commit interval 5 seconds
EXT3-fs: dm-0: orphan cleanup on readonly fs
ext3_orphan_cleanup: deleting unreferenced inode 12166184
ext3_orphan_cleanup: deleting unreferenced inode 12166183
....
ext3_orphan_cleanup: deleting unreferenced inode 12165430
ext3_orphan_cleanup: deleting unreferenced inode 6496446
EXT3-fs: dm-0: 19 orphan inodes deleted
========================================================================
thinkpad_acpi:
http://ibm-acpi.sf.net/
thinkpad_acpi: ThinkPad BIOS 7UET43WW (1.13 ), EC 7VHT12WW-1.01
thinkpad_acpi: Lenovo ThinkPad T400, model 276522G
thinkpad_acpi: radio switch found; radios are enabled
thinkpad_acpi: This ThinkPad has standard ACPI backlight brightness control, supported by the ACPI video driver
thinkpad_acpi: Disabling thinkpad-acpi brightness events by default...
Registered led device: tpacpi::thinklight
Registered led device: tpacpi:
ower
Registered led device: tpacpi
range:batt
Registered led device: tpacpi:green:batt
Registered led device: tpacpi::dock_active
Registered led device: tpacpi::bay_active
Registered led device: tpacpi::dock_batt
Registered led device: tpacpi::unknown_led
Registered led device: tpacpi::standby
thinkpad_acpi: Lenovo BIOS switched to ACPI backlight control mode
thinkpad_acpi: standard ACPI backlight interface available, not loading native one...
input: ThinkPad Extra Buttons as /devices/virtual/input/input10
Yenta: ISA IRQ mask 0x04b8, PCI irq 16
Socket status: 30000006
pcmcia: parent PCI bridge I/O window: 0x4000 - 0x7fff
cs: IO port probe 0x4000-0x7fff: clean.
pcmcia: parent PCI bridge Memory window: 0xf4800000 - 0xf7ffffff
pcmcia: parent PCI bridge Memory window: 0xf0000000 - 0xf3ffffff
sdhci-pci 0000:15:00.2: SDHCI controller found [1180:0822] (rev 21)
sdhci-pci 0000:15:00.2: PCI INT C -> GSI 18 (level, low) -> IRQ 18
sdhci-pci 0000:15:00.2: Will use DMA mode even though HW doesn't fully claim to support it.
Registered led device: mmc0
mmc0: SDHCI controller on PCI [0000:15:00.2] using DMA
i801_smbus 0000:00:1f.3: PCI INT A -> GSI 23 (level, low) -> IRQ 23
firewire_ohci 0000:15:00.1: PCI INT B -> GSI 17 (level, low) -> IRQ 17
firewire_ohci: Added fw-ohci device 0000:15:00.1, OHCI version 1.10
cs: IO port probe 0x100-0x3af: clean.
cs: IO port probe 0x3e0-0x4ff: excluding 0x4d0-0x4d7
cs: IO port probe 0x820-0x8ff: clean.
cs: IO port probe 0xc00-0xcf7: clean.
cs: IO port probe 0xa00-0xaff: clean.
iwlagn: Intel(R) Wireless WiFi Link AGN driver for Linux, 1.3.27kds
iwlagn: Copyright(c) 2003-2008 Intel Corporation
iwlagn 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
iwlagn 0000:03:00.0: setting latency timer to 64
iwlagn: Detected Intel Wireless WiFi Link 5300AGN REV=0x24
iwlagn: Tunable channels: 13 802.11bg, 24 802.11a channels
iwlagn 0000:03:00.0: PCI INT A disabled
phy0: Selected rate control algorithm 'iwl-agn-rs'
usb 4-2: new full speed USB device using uhci_hcd and address 3
usb 4-2: configuration #1 chosen from 1 choice
usb 4-2: New USB device found, idVendor=0a5c, idProduct=2145
usb 4-2: New USB device strings: Mfr=1, Product=2, SerialNumber=0
usb 4-2: Product: ThinkPad Bluetooth with Enhanced Data Rate II
usb 4-2: Manufacturer: Lenovo Computer Corp
firewire_core: created device fw0: GUID 00061b032a2fa5ac, S400
Bluetooth: Core ver 2.13
NET: Registered protocol family 31
Bluetooth: HCI device and connection manager initialized
Bluetooth: HCI socket layer initialized
HDA Intel 0000:00:1b.0: PCI INT B -> GSI 17 (level, low) -> IRQ 17
HDA Intel 0000:00:1b.0: setting latency timer to 64
Bluetooth: Generic Bluetooth USB driver ver 0.3
usbcore: registered new interface driver btusb
device-mapper: multipath: version 1.0.5 loaded
EXT3 FS on dm-0, internal journal
kjournald starting. Commit interval 5 seconds
EXT3 FS on sda1, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
Adding 4063224k swap on /dev/mapper/VolGroup00-LogVol01. Priority:-1 extents:1 across:4063224k
Why is my Fedora 10 hanging
