CentOS eth0

Electromancer · 01-24-2013, 05:09 PM

Hi,

I just installed CentOS 6.3 minimal.

I'm trying to reach the internet but no luck.

I run..
#ifconfig -a
And the only interfaces I see is lo, p4p1, wlan0

No eth0 exist!!

chrism01 · 01-24-2013, 05:17 PM

Please show the output of ifconfig.
Do you have an ethernet card plugged in from your host to your modem/router?
Do you have more than one physical eth port on your system?

Electromancer · 01-24-2013, 05:31 PM

#ifconfig
OUTPUT:
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)

My on-board nic is connected to a small switch.

I am not using an external internet card.

I have 1 physical eth port.

Electromancer · 01-24-2013, 06:20 PM

Disregard..

Interface p4p1 is my main interface.

After doing a ifconfig p4p1 up, i was able to reach the internet.