I've installed 10.2 and everything looks fine.
I did pppoe-setup and pppoe-start and I got the message "...Connected!"

But I can't log nor ping anything.

I've downloaded latest nForce driver from nVidia and compiled. It created a module called nvnet and I uploaded it but still nothing.

Any ideas?

specs:: (IP and Mask are ok.)

ubsystem: EPoX Computer Co., Ltd.: Unknown device 1000
Flags: bus master, 66Mhz, fast devsel, latency 0, IRQ 11
Memory at e6001000 (32-bit, non-prefetchable) [size=4K]
I/O ports at e000 [size=8]
Capabilities: [44] Power Management version 2

eth0 Link encap:Ethernet HWaddr 78:00:16:7E:B3:BF
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:11 Base address:0x1000

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)

Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo

cheers,

Hi

It seems like you don't have an IP number. Try netconfig and configure the card.

No you do not need IP address on eth0 for PPPoE

But you should have ppp0 interface

ifconfig should show ppp0 after pppoe-start gives you CONNECTED!

Did you set your DNS IP address correctly during pppoe-setup?

DUPLICATE. Something not right with the Post Fast Reply button.

yep, you don't have nor the interface nor the record in routing table. Doublecheck if script is supplied with correct values.