Hi Guys,

have installed a new HP all in one printer (PSC210) and have it running OK. When ever I start the PC I get a detected new hardware message with an option to configure a SCSI drive - sda. Selecting the configure option provides a selection of the existing drives to unmount. Using harddrake within the GUI also produces a similar result by starting diskdrake. Not sure what to do to configure the detected SCSI drive (the memory card reader part of the printer I assume). Have tried using the memory card reader and it works - a little slow. Below is the last part of the dmesg output.

Bye the way the only drama with the printer is that once I scan with it I cannot get the printer to print until I turn off the printer and then turn it on again.

Can anyone assist?

thanks

pugsley

Initializing USB Mass Storage driver...
scsi0 : SCSI emulation for USB Mass Storage devices
Vendor: HP Model: psc 2410 Rev: 1.00
Type: Direct-Access ANSI SCSI revision: 02
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 2
drivers/usb/core/usb.c: registered new driver usb-storage
USB Mass Storage support registered.
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
spurious 8259A interrupt: IRQ7.
Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0, type 0