Hi all,
If I am not wrong Suse comes with a driver for Cisco 350 the airo_cs.o.But when I plugin the card it detects it and loads the driver,then cannot create a dev entry for it and no eth0 appears on ifconfig.When I run acu(cisco utilities),no radio is detected,what is be the problem,any ideas will be helpful
Cheers,
Tisham.

Ps:Here is the System log
Apr 12 13:10:16 linux cardmgr[1050]: + Using /lib/modules/2.4.21-99-default/kernel/drivers/net/pcmcia/airo_cs.o
Apr 12 13:10:16 linux cardmgr[1050]: + Symbol version prefix ''
Apr 12 13:10:16 linux cardmgr[1050]: + /sbin/insmod /lib/modules/2.4.21-99-default/kernel/drivers/net/wireless/airo_cs.o
Apr 12 13:10:16 linux cardmgr[1050]: + Using /lib/modules/2.4.21-99-default/kernel/drivers/net/wireless/airo_cs.o
Apr 12 13:10:16 linux kernel: airo: Doing fast bap_reads
Apr 12 13:10:17 linux kernel: airo: Max tries exceeded waiting for command
Apr 12 13:10:17 linux kernel: airo: MAC could not be enabled
Apr 12 13:10:17 linux kernel: airo_cs: RequestConfiguration: Operation succeeded
Apr 12 13:10:18 linux cardmgr[1050]: get dev info on socket 1 failed: Resource temporarily unavailable

You can try my instructions... www.mzla.com/linux/airo350.htm

You did all that?? I just used the firmware given, and the drivers that came in the Slackware 9.1 and did an utilites only install of with the package from cisco. Then configured my card in /dev/drivers/aironet/eth0. Ran leapset and it was online.