I'm havening a weird problem. I'm using SuSE 10.0 on a Sager notebook with w built in Realtek NIC and an Intersil/Prism wireless.

If both the wired and wireless interfaces are enabled and configured I can access local addresses on my LAN, but I cannot connect to the Internet.

If I go into Yast and delete the wireless (so it is listed as "not configured") I can then connect to both the LAN and the Internet.

Here is a snip it from the startup log with both interfaces enabled:

Setting up network interfaces:
lo
lo IP address: 127.0.0.1/8
done eth0 device: Intersil Corporation Intersil ISL3890 [Prism GT/Prism Duette] (rev 01)
eth0 configuration: wlan-id-00:90:4b:2b:7d:ff
eth0 (DHCP) . . . . . <notice>checkproc: /opt/kde3/bin/kdm 5128
<notice>killproc: kill(5076,15)
no IP address yet... backgrounding.
waiting
eth1 device: Realtek Semiconductor Co., Ltd. RTL-8169 Gigabit Ethernet (rev 10)
eth1 configuration: eth-id-00:90:f5:27:08:d3
<notice>checkproc: /sbin/dhcpcd 5051
eth1 (DHCP) . IP/Netmask: 192.168.1.103 / 255.255.255.0
doneWaiting for mandatory devices: wlan-id-00:90:4b:2b:7d:ff
12 11 10 8 7 6 4 2 1
eth0 interface could not be set up
failedSetting up service network . . . . . . . . . . . . . . . .failed


Here is the log entry with the wireless not configured:

Setting up network interfaces:
lo
lo IP address: 127.0.0.1/8
done eth0 device: Intersil Corporation Intersil ISL3890 [Prism GT/Prism Duette] (rev 01)
eth0 No configuration found for eth0
unused eth1 device: Realtek Semiconductor Co., Ltd. RTL-8169 Gigabit Ethernet (rev 10)
eth1 configuration: eth-id-00:90:f5:27:08:d3
eth1 (DHCP) . IP/Netmask: 192.168.1.103 / 255.255.255.0
doneSetting up service network . . . . . . . . . . . . . . . .done

I noticed that either way the wired card is assigned the same IP address by the router, but I can connect only with the wireless card disabled.

Please help!

Thanks in advance!

are both devices going to the same router? if so, you're going to run into some routing issues.

I have an Acer 291LMI, and i'm facing the same problem. Hope someone can help us. Thanks in advance

you can't have your default gateway going through two devices. try this:How many results come up? If there is more than one and they have different Ifaces, that's gonna be a problem.

Also, chances are your wireless card isn't going to be recognized by YaST. You're just gonna have to get your hands dirty and use either a native driver or ndiswrapper to set it up. Search the web for what you need to do for that specific card.