gyach installation
Hello all,
i have red hat 8 on my system.
i downloaded "gyach-0.9.7.tar.gz".......
..........
i'm not sure about the installation procedure........
..........
i did the following steps:
1> tar xvzf gyach-0.9.7.tar.gz
2>when the directory gyach-0.9.7 was obtained i went inside the directory
there i wrote "./configure"..........it was configured properly..
3> now where to write "make"..........................is it "make" only or "make all install"......or what?
.........
i don't know the further steps
plz. help me
regards
ruudra
|