I recently installed Mandrake 9.2 on my laptop, everything seems to be working fine. However, when I try to connect using the built in wireless card, it does not work. Linux does not see the network card and does not seem to detect it using the Mandrake Control Center. How can I install/configure this card? I did check to make sure it was turned on and a number of other things, but I am stuck.

- Mike

can you run lspci -vv as root and post the output of the sections with "Network controller" in them, here's one of mine for example:

4:00.0 Network controller: Texas Instruments: Unknown device 8400
Subsystem: Texas Instruments: Unknown device 8402
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64
Interrupt: pin A routed to IRQ 11
Region 0: I/O ports at 4800 [size=32]
Region 1: Memory at 10c00000 (32-bit, non-prefetchable) [size=4K]
Region 2: Memory at 10c10000 (32-bit, non-prefetchable) [size=64K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-