Hi.
I recently purchased a
Ultra ULT33046 USB UPS.
Like your post, mine is correctly identified in /proc/bus/usb/devices:
T: Bus=03 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 2 Spd=1.5 MxCh= 0
D: Ver= 1.00 Cls=00(>ifc ) Sub=00 Prot=00 MxPS= 8 #Cfgs= 1
P: Vendor=0d9f ProdID=0002 Rev= 0.00
S: Manufacturer=POWERCOM CO., LTD.
S: Product=USB to Serial
C:* #Ifs= 1 Cfg#= 1 Atr=80 MxPwr=100mA
I: If#= 0 Alt= 0 #EPs= 2 Cls=03(HID ) Sub=00 Prot=00 Driver=usbhid
E: Ad=81(I) Atr=03(Int.) MxPS= 8 Ivl=10ms
E: Ad=02(O) Atr=03(Int.) MxPS= 8 Ivl=10ms
I'm not sure how to determine where it hotplugs. I am using Kubuntu Edgy 6.10 386.
I have cat /etc/nut/ups.conf as
[ups1]
driver=newhidups
port=auto
When I run uspd I end up with:
Network UPS Tools upsd 2.0.4
Can't bind TCP port number 3493: Address already in use
If I run upsdrvctl start I end up with:
Network UPS Tools - UPS driver controller 2.0.4
Network UPS Tools: New USB/HID UPS driver 0.28 (2.0.4)
No matching USB/HID UPS found
Driver failed to start (exit status=1)
Any help would be greatly appreciated. I'm confused at this point.