Hi,

I've just installed Webalizer 2.01-10 on my Red Hat 9.0 server. The installation went fine. I've setup webalizer.conf with the logs, outpudir and everything but my problem is this:

1- When I run webalizer from the command line, it seems to be working for a couple of minutes, I assume it compiles the logs, ( for about 2-3 minutes)and then I get the command line again. But when I try to check the result pages, all I see is zeros.. no hits! Exactly as if no one had visited my site, wich I'm shure is not true.

2- Another problem is the language, I use
"./configure --with=language=french" to install webalizer and it configure itself but the language does'nt change..

Any ideas?

Thanks for the help.