dsl connection and Firestarter
Can't get Firestarter firestarted!
I am in a flat in China. To get internet, I just plug in the wall. The connection requires a username and password, which I buy with a card. The connection works.
But Firestarter has problems, and I don't know why!
Here some info:
Active network connections:
Nanjing dsl (default)
Interface Ethernet (eth0)
Hardware Address 00:23:54:6C:1A:E8
Driver forcedeth
Speed 100 Mb/s
Security unknown
IP Address 58.212.224.158
Broadcast Address 58.212.224.158
Subnet Mask 255.255.255.255
Default Route 58.212.224.1
Primary DNS 218.2.135.1
Secondary DNS 61.147.37.1
If I try to start Firestarter I get a warning
The device eth0 is not ready
Please check your network device settings and make sure your network connection is active.
This is ifconfig
peter@vaya2:~$ ifconfig
eth0 Link encap:Ethernet HWaddr 00:23:54:6c:1a:e8
inet6 addr: fe80::223:54ff:fe6c:1ae8/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:68528 errors:0 dropped:0 overruns:0 frame:0
TX packets:12097 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:8289099 (8.2 MB) TX bytes:1726929 (1.7 MB)
Interrupt:218 Base address:0x6000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:386 errors:0 dropped:0 overruns:0 frame:0
TX packets:386 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:20208 (20.2 KB) TX bytes:20208 (20.2 KB)
ppp0 Link encap:Point-to-Point Protocol
inet addr:58.212.224.158 P-t-P:58.212.224.1 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1
RX packets:11176 errors:0 dropped:0 overruns:0 frame:0
TX packets:11644 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:4135848 (4.1 MB) TX bytes:1393897 (1.3 MB)
peter@vaya2:~$
|