Hi,
i'm a little surprised..... I installed openSuSE 10.3 and wanted to add my old prism usb wlan dongle (done that without any problem since suse 9.x till 10.2). I have set the method to "traditional" and tried to add the dongle in yast but this time it don't work.
I see wlan0 in yast/in the system but anyhow the system don't recognize this wlan0 correctly
Quote:
Oct 8 23:23:55 linux kernel: usb 1-1: new full speed USB device using uhci_hcd and address 6
Oct 8 23:23:56 linux kernel: usb 1-1: new device found, idVendor=0967, idProduct=0204
Oct 8 23:23:56 linux kernel: usb 1-1: new device strings: Mfr=0, Product=0, SerialNumber=1
Oct 8 23:23:56 linux kernel: usb 1-1: SerialNumber: KJLee
Oct 8 23:23:56 linux kernel: usb 1-1: configuration #1 chosen from 1 choice
Oct 8 23:23:56 linux ifup: wlan0
Oct 8 23:24:01 linux ifup-dhcp: Starting DHCP Client Daemon on wlan0...
Oct 8 23:24:01 linux dhcpcd[18609]: dhcpStart: ioctl SIOCSIFFLAGS: No such device
Oct 8 23:24:01 linux ifup-dhcp: .
Oct 8 23:24:06 linux syslog-ng[2117]: last message repeated 4 times
Oct 8 23:24:06 linux ifup-dhcp: no IP address yet... backgrounding.
Oct 8 23:24:06 linux ifup: Cannot enable interface wlan0.
Oct 8 23:24:06 linux ifup-route: interface wlan0 is not up
|
Quote:
# iwconfig
lo no wireless extensions.
wlan0 no wireless extensions.
eth0 no wireless extensions.
|
Quote:
# lsusb
Bus 004 Device 001: ID 0000:0000
Bus 003 Device 001: ID 0000:0000
Bus 002 Device 001: ID 0000:0000
Bus 001 Device 005: ID 0967:0204 Acer (??) WarpLink 802.11b Adapter
Bus 001 Device 004: ID 03f0:0505 Hewlett-Packard ScanJet 2100c
Bus 001 Device 001: ID 0000:0000
|
