Setup MN-510 wireless usb adapter on RH9
Hi
I am using the MN-510 wireless adpater to connecte to internet. I have RH9 installed and kernel version is 2.4.22
I followed all the steps for the usb driver installation but having problems starting up wlan0
During startup I get the following error
Bringing up interface wlan0: Error for wireless request "Set Encode" (8B2A) :
SET failed on device wlan0 ; Function not implemented.
Error for wireless request "Set ESSID" (8B1A) :
SET failed on devide wlan0 ; Function not implemented.
Determining IP information for wlan0... failed. [FAILED]
I made sure that the pcmcia_usb configs are good by running the following commands
[root@localhost root]# /etc/init.d/wlan start [ OK ]
[root@localhost root]# ifconfig wlan0
wlan0 Link encap:Ethernet HWaddr 00:50:F2:C4:ED:0B
inet addr:10.0.0.1 Bcast:10.255.255.255 Mask:255.0.0.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:0 (0.0 b) TX bytes:2016 (1.9 Kb)
Can anyone tell when I went wrong
Any help is appreciated.
Thanks
kolli
|