Hi,
I am using OpenSUSE 10.2 and set up my D-Link DWL-520+ Networkcard yesterday.
I did this with the Windows Driver and ndiswrapper:
Code:
ndiswrapper -i AIRPLUS.SYS
modprobe ndiswrapper
Now I had "wlan1" in the "iwconfig" list. So it gave it an essid and a WEP-Key:
Code:
iwconfig wlan1 essid "XXXX" key "XXXX-XXXX-XXXX-XX" channel 10 mode managed
So, everything ok till yet. iwconfig says now this:
Code:
wlan1 IEEE 802.11b ESSID:"XXXXX"
Mode:Managed Frequency:2.457 GHz Access Point: 00:01:E3:02:41:46
Bit Rate=11 Mb/s Tx-Power:0 dBm Sensitivity=0/3
RTS thr:off Fragment thr:off
Encryption key:XXXX-XXXX-XXXX-XX Security mode:restricted
Power Management:off
Link Quality:100/100 Signal level:-28 dBm Noise level:-256 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Now I entered "ifconfig wlan1 up" and everything worked perfect. I had connection to the internet and the whole network.
But when I started my Computer today there was no internet connection. I reinstalled the dirver but that was for nothing. Iwconfig looks the same as above, everything should be ok...?
What could be the problem?
Thank you!
ndiswrapper -l
Code:
installed drivers:
airplus driver installed, hardware (104C:8400) present
ifconfig
Code:
wlan1 Protokoll:Ethernet Hardware Adresse 00:0D:88:93:2C:A1
inet6 Adresse: fe80::20d:88ff:fe93:2ca1/64 Gültigkeitsbereich:Verbindung
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:146 errors:0 dropped:0 overruns:0 frame:0
TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 Sendewarteschlangenlänge:1000
RX bytes:23896 (23.3 Kb) TX bytes:468 (468.0 b)
Interrupt:21 Speicher:de010000-de011000
iwlist scan
Code:
wlan1 Scan completed :
Cell 01 - Address: 00:01:E3:02:41:46
ESSID:"XXXXXX"
Protocol:IEEE 802.11FH
Mode:Managed
Frequency:2.457 GHz (Channel 10)
Quality:0/100 Signal level:65/154 Noise level:0/154
Encryption key:on
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s
Extra:bcn_int=100
Extra:atim=0
