I installed centos5.3 on an domain, that's okay and it works well. But Xen server powers off suddenly, after the Xen server reboots, the domain cannot be booted successfully. I got the following messages:
Linux version 2.6.18-128.el5xen (mockbuild@builder16.centos.org) (gcc version 4.1.2 20080704 (Red Hat 4.1.2-44)) #1 SMP Wed Jan 21 11:55:02 EST 2009
BIOS-provided physical RAM map:
Xen: 0000000000000000 - 0000000080800000 (usable)
1328MB HIGHMEM available.
727MB LOWMEM available.
NX (Execute Disable) protection: active
ACPI in unprivileged domain disabled
Built 1 zonelists. Total pages: 526336
Kernel command line: ro root=/dev/VolGroup00/LogVol00 console=xvc0
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Initializing CPU#0
CPU 0 irqstacks, hard=c0744000 soft=c0724000
PID hash table entries: 4096 (order: 12, 16384 bytes)
Xen reported: 2000.066 MHz processor.
Console: colour dummy device 80x25
Dentry cache hash table entries: 131072 (order: 7, 524288 bytes)
Inode-cache hash table entries: 65536 (order: 6, 262144 bytes)
Software IO TLB disabled
vmalloc area: ee000000-f4ffe000, maxmem 2d7fe000
Memory: 2064452k/2105344k available (2124k kernel code, 31524k reserved, 877k data, 176k init, 1359880k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay using timer specific routine.. 5002.23 BogoMIPS (lpj=10004473)
Security Framework v1.0.0 initialized
SELinux: Initializing.
selinux_register_security: Registering secondary module capability
Capability LSM initialized as secondary
Mount-cache hash table entries: 512
CPU: L1 I cache: 32K, L1 D cache: 32K
CPU: L2 cache: 6144K
Checking 'hlt' instruction... OK.
SMP alternatives: switching to UP code
Freeing SMP alternatives: 13k freed
Brought up 1 CPUs
checking if image is initramfs... it is
Freeing initrd memory: 6728k freed
Grant table initialized
NET: Registered protocol family 16
ACPI Exception (utmutex-0262): AE_BAD_PARAMETER, Thread C06F2AA0 could not acquire Mutex [2] [20060707]
No dock devices found.
ACPI Exception (utmutex-0262): AE_BAD_PARAMETER, Thread C06F2AA0 could not acquire Mutex [2] [20060707]
Brought up 1 CPUs
PCI: setting up Xen PCI frontend stub
ACPI: Interpreter disabled.
Linux Plug and Play Support v0.97 (c) Adam Belay
pnp: PnP ACPI: disabled
xen_mem: Initialising balloon driver.
usbcore: registered new driver usbfs
usbcore: registered new driver hub
PCI: System does not support PCI
PCI: System does not support PCI
NetLabel: Initializing
NetLabel: domain hash size = 128
NetLabel: protocols = UNLABELED CIPSOv4
NetLabel: unlabeled traffic allowed by default
NET: Registered protocol family 2
IP route cache hash table entries: 32768 (order: 5, 131072 bytes)
TCP established hash table entries: 131072 (order: 8, 1048576 bytes)
TCP bind hash table entries: 65536 (order: 7, 524288 bytes)
TCP: Hash tables configured (established 131072 bind 65536)
TCP reno registered
audit: initializing netlink socket (disabled)
type=2000 audit(1292729541.120:1): initialized
highmem bounce pool size: 64 pages
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
Initializing Cryptographic API
alg: No test for crc32c (crc32c-generic)
ksign: Installing public key data
Loading keyring
- Added public key 4F03F897CD3DCED2
- User ID: CentOS (Kernel Module GPG key)
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered (default)
pci_hotplug: PCI Hot Plug PCI Core version: 0.5
rtc: IRQ 8 is not free.
Non-volatile memory driver v1.2
Linux agpgart interface v0.101 (c) Dave Jones
RAMDISK driver initialized: 16 RAM disks of 16384K size 4096 blocksize
Xen virtual console successfully installed as xvc0
Linux version 2.6.18-128.el5xen (mockbuild@builder16.centos.org) (gcc version 4.1.2 20080704 (Red Hat 4.1.2-44)) #1 SMP Wed Jan 21 11:55:02 EST 2009
BIOS-provided physical RAM map:
Xen: 0000000000000000 - 0000000080800000 (usable)
1328MB HIGHMEM available.
727MB LOWMEM available.
NX (Execute Disable) protection: active
ACPI in unprivileged domain disabled
Built 1 zonelists. Total pages: 526336
Kernel command line: ro root=/dev/VolGroup00/LogVol00 console=xvc0
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Initializing CPU#0
CPU 0 irqstacks, hard=c0744000 soft=c0724000
PID hash table entries: 4096 (order: 12, 16384 bytes)
Xen reported: 2000.066 MHz processor.
Console: colour dummy device 80x25
Dentry cache hash table entries: 131072 (order: 7, 524288 bytes)
Inode-cache hash table entries: 65536 (order: 6, 262144 bytes)
Software IO TLB disabled
vmalloc area: ee000000-f4ffe000, maxmem 2d7fe000
Memory: 2064452k/2105344k available (2124k kernel code, 31524k reserved, 877k data, 176k init, 1359880k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay using timer specific routine.. 5002.23 BogoMIPS (lpj=10004473)
Security Framework v1.0.0 initialized
SELinux: Initializing.
selinux_register_security: Registering secondary module capability
Capability LSM initialized as secondary
Mount-cache hash table entries: 512
CPU: L1 I cache: 32K, L1 D cache: 32K
CPU: L2 cache: 6144K
Checking 'hlt' instruction... OK.
SMP alternatives: switching to UP code
Freeing SMP alternatives: 13k freed
Brought up 1 CPUs
checking if image is initramfs... it is
Freeing initrd memory: 6728k freed
Grant table initialized
NET: Registered protocol family 16
ACPI Exception (utmutex-0262): AE_BAD_PARAMETER, Thread C06F2AA0 could not acquire Mutex [2] [20060707]
No dock devices found.
ACPI Exception (utmutex-0262): AE_BAD_PARAMETER, Thread C06F2AA0 could not acquire Mutex [2] [20060707]
Brought up 1 CPUs
PCI: setting up Xen PCI frontend stub
ACPI: Interpreter disabled.
Linux Plug and Play Support v0.97 (c) Adam Belay
pnp: PnP ACPI: disabled
xen_mem: Initialising balloon driver.
usbcore: registered new driver usbfs
usbcore: registered new driver hub
PCI: System does not support PCI
PCI: System does not support PCI
NetLabel: Initializing
NetLabel: domain hash size = 128
NetLabel: protocols = UNLABELED CIPSOv4
NetLabel: unlabeled traffic allowed by default
NET: Registered protocol family 2
IP route cache hash table entries: 32768 (order: 5, 131072 bytes)
TCP established hash table entries: 131072 (order: 8, 1048576 bytes)
TCP bind hash table entries: 65536 (order: 7, 524288 bytes)
TCP: Hash tables configured (established 131072 bind 65536)
TCP reno registered
audit: initializing netlink socket (disabled)
type=2000 audit(1292729541.120:1): initialized
highmem bounce pool size: 64 pages
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
Initializing Cryptographic API
alg: No test for crc32c (crc32c-generic)
ksign: Installing public key data
Loading keyring
- Added public key 4F03F897CD3DCED2
- User ID: CentOS (Kernel Module GPG key)
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered (default)
pci_hotplug: PCI Hot Plug PCI Core version: 0.5
rtc: IRQ 8 is not free.
Non-volatile memory driver v1.2
Linux agpgart interface v0.101 (c) Dave Jones
RAMDISK driver initialized: 16 RAM disks of 16384K size 4096 blocksize
Xen virtual console successfully installed as xvc0
Event-channel device installed.
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
ide-floppy driver 0.99.newide
usbcore: registered new driver hiddev
usbcore: registered new driver usbhid
drivers/usb/input/hid-core.c: v2.6:USB HID core driver
PNP: No PS/2 controller found. Probing ports directly.
i8042.c: No controller found.
mice: PS/2 mouse device common for all mice
md: md driver 0.90.3 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: bitmap version 4.39
TCP bic registered
Initializing IPsec netlink socket
NET: Registered protocol family 1
NET: Registered protocol family 17
Using IPI No-Shortcut mode
XENBUS: Device with no driver: device/vbd/51712
XENBUS: Device with no driver: device/vif/0
XENBUS: Device with no driver: device/vif/1
XENBUS: Device with no driver: device/vif/2
Freeing unused kernel memory: 176k freed
Write protecting the kernel read-only data: 383k
Red Hat nash version 5.1.19.6 starting
Mounting proc filesystem
Mounting sysfs filesystem
Creating /dev
Creating initial device nodes
Setting up hotplug.
Creating block device nodes.
Loading ehci-hcd.ko module
Loading ohci-hcd.ko module
Loading uhci-hcd.ko module
USB Universal Host Controller Interface driver v3.0
Loading jbd.ko module
Loading ext3.ko module
Loading xenblk.ko module
Registering block device major 202
xvda: xvda1 xvda2
Loading dm-mod.ko module
device-mapper: uevent: version 1.0.3
device-mapper: ioctl: 4.11.5-ioctl (2007-12-12) initialised:
dm-devel@redhat.com
Loading dm-log.ko module
Loading dm-mirror.ko module
Loading dm-zero.ko module
Loading dm-snapshot.ko module
Loading dm-mem-cache.ko module
Loading dm-region_hash.ko module
Loading dm-message.ko module
Loading dm-raid45.ko module
device-mapper: dm-raid45: initialized v0.2429
Scanning and configuring dmraid supported devices
Scanning logical volumes
Reading all physical volumes. This may take a while...
Found volume group "VolGroup00" using metadata type lvm2
Activating logical volumes
2 logical volume(s) in volume group "VolGroup00" now active
Creating root device.
Mounting root filesystem.
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Setting up other filesystems.
Setting up new root fs
no fstab.sys, mounting internal defaults
Switching to new root and running init.
unmounting old /dev
unmounting old /proc
unmounting old /sys
EXT3-fs error (device dm-0): ext3_lookup: unlinked inode 26477853 in dir #26476545
exec of init (/sbin/init) failed!!!: No such file or directory
Kernel panic - not syncing: Attempted to kill init!
Could you help me to fix this issue? Thank you very much!
Best Regards
