hi
i had installed slackware 11
and then installed wine
when i run wincfg ton configure wine these errors come:

root@AGK:~# winecfg
wine: glibc >= 2.3 without NPTL or TLS is not a supported combination.
It will most likely crash. Please upgrade to a glibc with NPTL support.
err:imagelist:ImageList_ReplaceIcon no color!
err:imagelist:ImageList_ReplaceIcon no color!
err:imagelist:ImageList_ReplaceIcon no color!
err:imagelist:ImageList_ReplaceIcon no color!
wine: glibc >= 2.3 without NPTL or TLS is not a supported combination.
It will most likely crash. Please upgrade to a glibc with NPTL support.
Application tried to create a window, but no driver could be loaded.
Make sure that your X server is running and that $DISPLAY is set correctly.
Application tried to create a window, but no driver could be loaded.
Make sure that your X server is running and that $DISPLAY is set correctly.
root@AGK:~#

i thought that i have a problem in my vedio card so i run

root@AGK:~# lspci
00:00.0 Host bridge: Intel Corporation 440BX/ZX/DX - 82443BX/ZX/DX Host bridge (rev 03)
00:01.0 PCI bridge: Intel Corporation 440BX/ZX/DX - 82443BX/ZX/DX AGP bridge (rev 03)
00:07.0 ISA bridge: Intel Corporation 82371AB/EB/MB PIIX4 ISA (rev 02)
00:07.1 IDE interface: Intel Corporation 82371AB/EB/MB PIIX4 IDE (rev 01)
00:07.2 USB Controller: Intel Corporation 82371AB/EB/MB PIIX4 USB (rev 01)
00:07.3 Bridge: Intel Corporation 82371AB/EB/MB PIIX4 ACPI (rev 02)
00:0a.0 Multimedia audio controller: Ensoniq 5880 AudioPCI (rev 02)
00:0b.0 Ethernet controller: Hangzhou Silan Microelectronics Co., Ltd. RTL8139D [Realtek] PCI 10/100BaseTX ethernet adaptor (rev 01)
01:00.0 VGA compatible controller: nVidia Corporation NV11 [GeForce2 MX/MX 400] (rev b2)
root@AGK:~#

i downloaded the driver from nividia site
and tried to install it like that

root@AGK:/Data# sh NVIDIA-Linux-x86-1.0-9755-pkg1.run
it said that it is not the driver for it
what shall i do now??!!!!

Unfortunately, Wine does not work well on Slackware 11 due to it's unusual kernel configuration: a 2.4 kernel and a 2.6 kernel available, with glibc compiled against both. This tends to confuse Wine a bit and make it difficult to get installed/started.

At the very least you must install and run the 2.6 kernel from the /testing directory of the Slackware CDs. But honestly, you are much better off installing Slackware 12 at this point; as it has made huge improvements over Slackware 11, among them the abandonment of the 2.4 kernel series and the problems it was causing.

i have a problem with slack 12
coz it use kernel 2.6
and i have a realtech ,it's driver supports kernel 2.4 and 2.5 only
so if i use slack 12 i will not be able to log on the net
any other solutions??

No, Wine only works with a 2.6 kernel, it has dropped support for anything older than that.

You will either need to get a new network card (or see if there is an updated driver yet) or not use Wine, basically.