emu10k1 problems on slackware

joel112 · 06-10-2003, 02:59 AM

i have downloaded and installed the drivers, but i have to manually start them all the time with

emu-dspmgr -y
and
emu-dspconfig -d

i have done the emu script thing, and added the right line to /etc/modules.conf but it doesnt seem to run the setup script automatically, coz if i run it from a prompt, it works fine....

also the digital out is a bit quiet, even with all volumes at full, is there any way to increase this output

cheers

unSpawn · 06-13-2003, 04:00 AM

If this is still a problem, add the emu.* lines to the appropriate bootscript.

neenee · 06-13-2003, 04:08 AM

please check this thread. i have written out the
complete alsa installation when on slackware;
just ignore the bits about bttv. you can check
there if you have forgotten something.

joel112 · 06-13-2003, 04:18 AM

cheers, does the alsa drivers support digital out and ac3 passthrough?

neenee · 06-13-2003, 05:08 AM

both ac3 and digital output are supported.

joel112 · 06-13-2003, 05:18 AM

nevermind, the drivers from sourceforge work now...

cheers mate

neenee · 06-13-2003, 06:52 AM

glad to hear it.