Hi,
I am using Technisat SkyStar2 DVB card on Fedora13.
Its detected in the system:
lspci |grep -i Skystar2
Code:
03:04.0 Network controller: Techsan Electronics Co Ltd B2C2 FlexCopII DVB chip / Technisat SkyStar2 DVB card (rev 02)
When I do
dmesg |grep flex
I get following:
Code:
# dmesg |grep flex
b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully
flexcop-pci: will use the HW PID filter.
flexcop-pci: card revision 2
b2c2_flexcop_pci 0000:03:04.0: PCI INT A -> GSI 20 (level, low) -> IRQ 20
Modules linked in: b2c2_flexcop_pci(+) b2c2_flexcop via_rhine mii sky2 ppdev i2c_i801 dvb_core cx24123 cx24113 s5h1420 parport_pc parport microcode soundcore snd_page_alloc pcspkr i915 drm_kms_helper drm i2c_algo_bit i2c_core video output [last unloaded: scsi_wait_scan]
[<fa2dd15f>] ? flexcop_pci_isr+0x0/0x262 [b2c2_flexcop_pci]
[<fa2dd520>] flexcop_pci_probe+0x15f/0x27b [b2c2_flexcop_pci]
[<fa2e1000>] ? flexcop_pci_module_init+0x0/0x19 [b2c2_flexcop_pci]
[<fa2e1017>] flexcop_pci_module_init+0x17/0x19 [b2c2_flexcop_pci]
b2c2-flexcop: MAC address = 00:08:c9:e0:5a:46
b2c2-flexcop: no frontend driver found for this B2C2/FlexCop adapter
b2c2_flexcop_pci 0000:03:04.0: PCI INT A disabled
I have downloaded the Linux Driver for my card
http://www.technisat.com/indexe8ab.h...ucts,en,76-444
Followed all the instructions in README and everything is sucessful.
Where I am going wrong?Can some one shed some light?
b2c2-flexcop: no frontend driver found for this B2C2/FlexCop adapter
