[SOLVED] Wireless internet works only when LAN is disconnected

Banquo · 02-01-2014, 09:34 AM

I'm afraid that did not do the trick

route:

Code:

Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
default         192.168.1.254   0.0.0.0         UG    0      0        0 wlan0
link-local      *               255.255.0.0     U     1000   0        0 eth0
192.168.1.0     *               255.255.255.0   U     2      0        0 wlan0
192.168.3.208   *               255.255.255.248 U     1      0        0 eth0

ifconfig:

Code:

eth0      Link encap:Ethernet  HWaddr 3d:6a:c5:3f:48:66   
          inet addr:192.168.3.213  Bcast:192.168.3.215  Mask:255.255.255.248
          inet6 addr: fe80::215:c5ff:fe3f:4866/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:3394 errors:0 dropped:0 overruns:0 frame:0
          TX packets:3448 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:279959 (279.9 KB)  TX bytes:275263 (275.2 KB)
          Interrupt:18 

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:1120 errors:0 dropped:0 overruns:0 frame:0
          TX packets:1120 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:81287 (81.2 KB)  TX bytes:81287 (81.2 KB)

wlan0     Link encap:Ethernet  HWaddr 4a:14:8b:2d:4a:35  
          inet addr:192.168.1.115  Bcast:192.168.1.255  Mask:255.255.255.0
          inet6 addr: fe80::21c:26ff:fe7f:c66/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:2043 errors:0 dropped:0 overruns:0 frame:0
          TX packets:927 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:526957 (526.9 KB)  TX bytes:135671 (135.6 KB)

Banquo · 02-01-2014, 09:44 AM

Never mind, it did work! I had set DHCP on the wireless adapter to address only while i was looking through the options after I had changed the subnet and IPs for the lan. It didn't work at first. It seem I had to set IPs for the hosts to a number above the router. Weird.

Thanks again for the help! It is greatly appreciated!