my system configuration is

Form Factor microATX (9.60 inches by 8.60 inches [243.84 mm by 218.44 mm])
Processor
Support for an Intel® Pentium® D Processor in an LGA775 socket with an 800 MHz system bus
Support for an Intel® Pentium® 4 Processor in an LGA775 socket with an 800 or 533 MHz system bus
Support for an Intel® Celeron® D Processor in an LGA775 socket with a 533 MHz system bus
View all supported processors
Memory
Two DDR SDRAM Dual Inline Memory Module (DIMM) sockets
Support for DDR 400 MHz and DDR 333 MHz DIMMs
Support for up to 2 GB of system memory
Chipset ATI* Radeon* Xpress 200 Chipset
BIOS AwardBIOS* for Intel resident in the 4 Mbit FWH
I/O Control SMSC* SCH5017 Legacy I/O controller for hardware management, diskette drive, serial, parallel, and PS/2 ports
Audio High Definition Audio subsystem using the Realtek* ALC861 audio codec
Video Integrated ATI* Radeon* X300 based graphics
LAN Support 10/100 Mbits/sec LAN subsystem using the Realtek* 8101L LAN adapter device
Peripheral Interfaces
Eight USB 2.0 ports
One serial port
One parallel port
Four Serial ATA interfaces
Two parallel ATA IDE interfaces with UDMA 33, ATA-66/100 support
One diskette drive interface
PS/2 keyboard and mouse ports
Expansion Capabilities
Two PCI Conventional* bus connectors
One PCI Express* x1 bus add-in card connector
One PCI Express* x16 bus add-in card connector
and Intel Pentium D 820 processor with 2.8GHz
But
I halt in installing linux in my system
which are fedora 5,6 and redhat 9 and suse10.1.
Redhat9 and suse10.1 are installed in safemode which intend to text mode.which version I have to use.and I have find drivers for my mother board in

www.ati.amd.com/support/driver.html

But I dont know how to install it.I am thinking to replace my mother board with Intel d945GPM for only linux.I am so worrying about it.Plz help me.

http://ubuntuguide.org/wiki/Fedora_fc5


http://ubuntuguide.org/wiki/Fedora_f...iver_.28ATI.29

(Remember that this guide is for Fedora 6 but you can also access the Fedora 5 guide from here.)

That guide can help installing the ATI drivers for Fedora. You should be able to install the ATI drivers for Suse with Yast. Not sure that I understand the entire question though.

Perhaps you should attempt to boot a live-evaluation CD like SimplyMepis. If everything is recognized and you get to a desktop, it should install easily. Wish I could be of more help, but at least this response keeps your question in the list of "new" posts.

i use the same configuration of system as u do.... where does it gets struck exactly??? pls be specific...