I have a Speedtouch 330 USB modem. The speedtouchconf script provided by Steve Parker gets it working. The script then asks if I want to set it to automatically dial-up when the PC boots up. I answer 'Yes' and then I get the following error message:

insserv: Service ALL has to be enabled for service speedtouch
insserv: exiting now!
init command failed

The script then says:

You can still stop and start the interface with
/etc/init.d/speedtouch stop
/etc/init.d/speedtouch start

However on my next boot when I try the above, it fails to connect. I end up having to run another script to undo everything, reboot, and then re-run speedtouchconf again.

Any help would be much appreciated.

does this help?

do you get any output? or post 'dmesg | grep -i usb'

Today I tried ' /etc/init.d/speedtouch start' after booting and this time it worked.

Previously I received the message:
'Starting ADSL connection: failed'

Today it said:
'Starting ADSL connection: done'.

I don't know why it worked this time.

Anyway, I entered the suggested line: '/usr/lib/lsb/install_initd /etc/init.d/speedtouch' again, and that still didn't work. I once again receive the message:

insserv: Service ALL has to be enabled for service speedtouch
insserv: exiting now!

I entered the line: 'dmesg | grep -i usb2' as suggested. It gave this output:

PCI0 PCI1 UAR1 UAR2 PS2K PS2M USB0 USB1 MMAC
usbcore: registered new driver usbfs
usbcore: registered new driver hub
ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI)
ohci_hcd 0000:00:02.0: new USB bus registered, assigned bus number 1
hub 1-0:1.0: USB hub found
ohci_hcd 0000:00:03.0: new USB bus registered, assigned bus number 2
hub 2-0:1.0: USB hub found
usb 1-1: new full speed USB device using ohci_hcd and address 2
hub 1-1:1.0: USB hub found
usb 1-1.2: new full speed USB device using ohci_hcd and address 3
usb 1-1.4: new full speed USB device using ohci_hcd and address 4
Initializing USB Mass Storage driver...
scsi0 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 4
usb-storage: waiting for device to settle before scanning
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
usbatm: module not supported by Novell, setting U taint flag.
usb 1-1.2: reset full speed USB device using ohci_hcd and address 3
usbcore: registered new driver speedtch
Vendor: Generic Model: USB SD Reader Rev: 1.00
Vendor: Generic Model: USB CF Reader Rev: 1.01
Vendor: Generic Model: USB SM Reader Rev: 1.02
Vendor: Generic Model: USB MS Reader Rev: 1.03
usb-storage: device scan complete
usbcore: deregistering driver speedtch