Greetings,
I've search what I have of the archives (approx 35,000 messages) and
can't seem to find anything related to this problem.
Here's what I've done:
Installed a clean copy of the 2.6.5-1.358 source from distrubtion.
Did a make oldconfig > make > make modules >make modules_install > make
install
That seems to have given me a bootable kernel.
Next, I followed the instructions for adding the it8212 RAID controller
to the kernel from here:
http://www.passys.nl/tips/ite_kernel_image_compile.txt , specifically,
In "Kconfig.in" I added (without the ""):
"config SCSI_ITE_RAID
tristate "ITE IT8212 support"
depends on SCSI && PCI && EXPERIMENTAL
help
For use of the ITE IT8212 RAID controller.
If unsure, say N. "
Below the SCSI_SATA_VIA rules.
and in "Makefile" I added (without the ""):
"obj-$(CONFIG_SCSI_ITE_RAID) += iteraid.o"
Below the line about the Sata_Via module.
(After determining that the file is Kconfig, not Kconfig.in)
Then ran make menuconfig, selecting the iteraid driver.
rebuilt the kernel, and rebooted.
Added an /etc/rc.modules to load at boot time
This all seemed to work.
However, when I do the modprob iteraid (or when the rc.modules file gets
executed), I get the following:
atkbd.c: Unknown key pressed (translated set 2, code 0x0 on isa0060/serio0).
atkbd.c: Use 'setkeycodes 00 <keycode>' to make it known.
Afterwards, just about anything I attempt to do generates these messages.
If boot *without* the iteraid module (comment it out of the rc.modules), things work fine.
I'm at a loss...Any ideas?
TIA
Brian
