Hi there
I successfully installed opensuse 10.0 on a thinkpad 770X -> fine, except
that I fail to get my PCMCIA network card running.
Its a Belkin F5D50101 (reported to be supported by linux for a long time), which runs fine with win2000 on that laptop.
usb works fine with udev: udevmonitor reports any plug event related to usb.
But udevmonitor keeps silent if I plug/unplug any pcmcia/pccard
below I give the result from lsmod and lspci.
Someone told me these 32bit cards do not use pcnet_cs modules any more, which coincides to the fact that pccardctl (the cardctl/cardmgr replcement) does not report any plugged devices.
Thanks for any hints.
lsmod reports:
Module Size Used by
nls_iso8859_1 4096 1
nls_cp437 5760 1
usb_storage 72512 1
parport_pc 38980 1
lp 11460 0
parport 33864 2 parport_pc,lp
sg 35744 0
st 38944 0
sd_mod 18576 2
sr_mod 16420 0
scsi_mod 131304 5 usb_storage,sg,st,sd_mod,sr_mod
iptable_filter 2816 0
ip_tables 19456 1 iptable_filter
joydev 9408 0
hfsplus 75140 0
vfat 12800 1
fat 49692 1 vfat
subfs 7552 2
speedstep_lib 4228 0
freq_table 4612 0
edd 9824 0
button 7056 0
battery 10244 0
ac 5252 0
ipv6 242752 10
pcmcia 37176 0
firmware_class 9856 1 pcmcia
uhci_hcd 32016 0
usbcore 112640 3 usb_storage,uhci_hcd
i2c_piix4 8720 0
i2c_core 20368 1 i2c_piix4
pci_hotplug 26164 0
yenta_socket 23820 2
rsrc_nonstatic 12800 1 yenta_socket
pcmcia_core 39952 3 pcmcia,yenta_socket,rsrc_nonstatic
generic 4484 0 [permanent]
intel_agp 22044 1
agpgart 33096 1 intel_agp
dm_mod 54972 0
ext3 130440 1
jbd 59940 1 ext3
fan 4996 0
thermal 14472 0
ide_cd 39684 0
cdrom 36896 2 sr_mod,ide_cd
processor 24252 1 thermal
piix 9988 0 [permanent]
ide_disk 17152 4
ide_core 122380 5 usb_storage,generic,ide_cd,piix,ide_disk
*******************************************************
Heres what lspci -vvv reports (sorry for the line breakings):
00:00.0 Host bridge: Intel Corporation 440BX/ZX/DX - 82443BX/ZX/DX Host bridge (rev 02)
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort+ >SERR- <PERR-
Latency: 64
Region 0: Memory at 40000000 (32-bit, prefetchable) [size=64M]
Capabilities: [a0] AGP version 1.0
Status: RQ=32 Iso- ArqSz=0 Cal=0 SBA+ ITACoh- GART64- HTrans- 64bit- FW- AGP3- Rate=x1
Command: RQ=1 ArqSz=0 Cal=0 SBA- AGP- GART64- 64bit- FW- Rate=<none>
00:01.0 PCI bridge: Intel Corporation 440BX/ZX/DX - 82443BX/ZX/DX AGP bridge (rev 02) (prog-if 00 [Normal decode])
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66MHz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 168
Bus: primary=00, secondary=01, subordinate=01, sec-latency=176
I/O behind bridge: 0000d000-0000dfff
Memory behind bridge: 70000000-dfffffff
Prefetchable memory behind bridge: e0000000-f7ffffff
Secondary status: 66MHz+ FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort+ <SERR- <PERR-
BridgeCtl: Parity- SERR- NoISA- VGA+ MAbort- >Reset- FastB2B+
00:02.0 CardBus bridge: Texas Instruments PCI1251A
Subsystem: IBM: Unknown device 00eb
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 168, Cache Line Size 20
Interrupt: pin A routed to IRQ 9
Region 0: Memory at 50102000 (32-bit, non-prefetchable) [size=4K]
Bus: primary=00, secondary=02, subordinate=05, sec-latency=176
Memory window 0: 14000000-15fff000 (prefetchable)
Memory window 1: 16000000-17fff000
I/O window 0: 00002000-00002fff
I/O window 1: 00003000-00003fff
BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset+ 16bInt+ PostWrite+
16-bit legacy interface ports at 0001
00:02.1 CardBus bridge: Texas Instruments PCI1251A
Subsystem: IBM: Unknown device 00eb
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 168, Cache Line Size 20
Interrupt: pin B routed to IRQ 9
Region 0: Memory at 50101000 (32-bit, non-prefetchable) [size=4K]
Bus: primary=00, secondary=06, subordinate=09, sec-latency=176
Memory window 0: 18000000-19fff000 (prefetchable)
Memory window 1: 1a000000-1bfff000
I/O window 0: 00004000-00004fff
I/O window 1: 00005000-00005fff
BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset+ 16bInt- PostWrite+
16-bit legacy interface ports at 0001
00:06.0 Multimedia audio controller: Cirrus Logic CS 4610/11 [CrystalClear SoundFusion Audio Accelerator] (rev 01)
Subsystem: IBM CS4610 SoundFusion Audio Accelerator
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 32 (1000ns min, 6000ns max)
Interrupt: pin A routed to IRQ 9
Region 0: Memory at 50100000 (32-bit, non-prefetchable) [size=4K]
Region 1: Memory at 50000000 (32-bit, non-prefetchable) [size=1M]
00:07.0 Bridge: Intel Corporation 82371AB/EB/MB PIIX4 ISA (rev 02)
Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 0
00:07.1 IDE interface: Intel Corporation 82371AB/EB/MB PIIX4 IDE (rev 01) (prog-if 80 [Master])
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 32
Region 4: I/O ports at fcf0 [size=16]
00:07.2 USB Controller: Intel Corporation 82371AB/EB/MB PIIX4 USB (rev 01) (prog-if 00 [UHCI])
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 48
Interrupt: pin D routed to IRQ 9
Region 4: I/O ports at 8400 [size=32]
00:07.3 Bridge: Intel Corporation 82371AB/EB/MB PIIX4 ACPI (rev 02)
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin ? routed to IRQ 9
01:00.0 VGA compatible controller: Trident Microsystems Cyber 9397DVD (rev f3) (prog-if 00 [VGA])
Subsystem: IBM: Unknown device 00ea
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 32
Interrupt: pin A routed to IRQ 11
Region 0: Memory at 70800000 (32-bit, non-prefetchable) [size=8M]
Region 1: Memory at 71000000 (32-bit, non-prefetchable) [size=128K]
Region 2: Memory at 70000000 (32-bit, non-prefetchable) [size=8M]
[virtual] Expansion ROM at e0000000 [disabled] [size=64K]
Capabilities: [80] AGP version 1.0
Status: RQ=33 Iso- ArqSz=0 Cal=0 SBA+ ITACoh- GART64- HTrans- 64bit- FW- AGP3- Rate=x1,x2
Command: RQ=1 ArqSz=0 Cal=0 SBA- AGP- GART64- 64bit- FW- Rate=<none>
Capabilities: [90] Power Management version 1
Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Solution !
