slackware 10.2 not responding after compile kernel 2.6.13

cwwilson721 · 02-21-2006, 01:46 PM

Different keyboard=different config on the layout...

Can you post your lspci, lsmod here?

I'm using 2.6.15, but I think I have my 2.6.13 config here. Just remember that I may have different hardware/filesystem than you, so be careful.

Finlay · 02-21-2006, 01:46 PM

ok so during the slackware install the keyboard works, then you reboot and it doesn't? Does it work at the lilo prompt?

lestoil · 02-21-2006, 01:55 PM

Dark sometimes the PS/2 KB can lock up on lappys. You can go into BIOS and turn off legacy usb support and see if that works until you troubleshoot the rest of problems with setup. An older lappy may have a twitchy BIOS so noacpi may be needed,using apm instead. IF your lappy or pc is more recent then probably not a problem. Follow finley suggestion otherwise.
If you go to the SW10.2 (any mirror) dl site look under 10.2 /testing/kernel for 2.6.13 kernel .config file.Good luck

Dark() · 02-22-2006, 03:59 PM

I discovered,that may new kernel 2.6.13 do not work (keyboard problem) after executing rc.hotplug at boot time.
It's interesting,that if I run it (rc.hotplug) form shell my keyboard don't stuck.I use this manual for compiling kernel http://www.linuxquestions.org/linux/...Slackware_10_1