Hello,
I'm trying to connect to a wireless network using a Thinkpad T42 with built in wireless card Intel 2100. I successfully installed the ipw2100 module. I have been trying to associate it with the network essid "NETGEAR", which uses WEP encryption. Here is the output of iwconfig:
eth3 unassociated ESSID:"NETGEAR" Nickname:"ipw2100"
Mode:Managed Channel=0 Access Point: Not-Associated
Bit Rate=0 kb/s Tx-Power:16 dBm
Retry min limit:7 RTS thr
ff Fragment thr
ff
Encryption key
ff
Power Management
ff
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
When I try
# iwconfig eth3 key [the key]
I get:
Error for wireless request "Set Encode" (8B2A) :
SET failed on device eth3 ; Operation not supported.
iwlist eth3 scan gets:
eth3 Scan completed :
Cell 01 - Address: 00:0F:B5:C1:61:8E
ESSID:"NETGEAR"
Protocol:IEEE 802.11bg
Mode:Master
Channel:11
Encryption key
n
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 6 Mb/s; 9 Mb/s
11 Mb/s; 12 Mb/s; 18 Mb/s; 22 Mb/s; 24 Mb/s
36 Mb/s; 48 Mb/s; 54 Mb/s
Quality:79 Signal level:0 Noise level:0
Extra: Last beacon: 99ms ago
Thank you for any advice you can give!