Hello,
I'm having difficulty with wireless on Fedora 10 on a Targa Traveller laptop.
This is a dual-boot system. Windows XP wireless works OK.
With the hardware button, the wireless is switched on.
The wireless adapter :
Code:
02:09.0 Ethernet controller: Linksys, A Division of Cisco Systems [AirConn] INPROCOMM IPN 2220 Wireless LAN Adapter (rev 01)
Subsystem: Micro-Star International Co., Ltd. Device 6855
Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV+ VGASnoop- ParErr- Stepping- SERR+ FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 64 (8000ns min, 8000ns max)
Interrupt: pin A routed to IRQ 5
Region 0: I/O ports at e400 [size=32]
Region 1: Memory at fbfff800 (32-bit, non-prefetchable) [size=32]
Region 2: Memory at fbffe800 (32-bit, non-prefetchable) [size=2K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI+ D1- D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
ipw2200 is installed :
Code:
[root@eddy eddy]# yum install ipw2200-firmware
Loaded plugins: refresh-packagekit
Setting up Install Process
Package ipw2200-firmware-3.1-1.fc10.noarch already installed and latest version
Nothing to do
the module is clearly not loaded :
Code:
[root@eddy eddy]# lsmod | grep 2200
So I load the module :
Code:
[root@eddy eddy]# modprobe ipw2200
I then see :
Code:
[root@eddy eddy]# lsmod | grep 2200
ipw2200 126536 0
ieee80211 27848 1 ipw2200
But NetworkManager still sees no wireless adapter... only the eth0.
So what are the steps I still need to take ?