I am trying to setup a Windows to Linux VPN connection but in the PPP config it says to do this:
http://www.cayugalake.net/index.php?...inux-PPTP.html
# IMPORTANT RESTRICTIONS:
#
# 1. No spaces are permitted between commas or within addresses.
#
# 2. If you give more IP addresses than the value of connections,
# it will start at the beginning of the list and go until it
# gets connections IPs. Others will be ignored.
#
# 3. No shortcuts in ranges! ie. 234-8 does not mean 234 to 238,
# you must type 234-238 if you mean this.
#
# 4. If you give a single localIP, that's ok - all local IPs will
# be set to the given one. You MUST still give at least one remote
# IP for each simultaneous client.
# (Recommended)
localip 192.168.1.50
remoteip 192.168.1.51-60
I typed ifconfig but I don't get any information about my dubnet whether 192 or 10.x.x.x
Any ideas on what to put in the config file?
Quote:
[root@server88-xxx-xxx-xx8 ~]# ifconfig -a
eth0 Link encap:Ethernet HWaddr 00:19:99:63:5A:A3
inet addr:88.xxx.xxx.xx8 Bcast:88.208.239.255 Mask:255.255.252.0
inet6 addr: fe80::219:99ff:fe63:5aa3/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:575626859 errors:0 dropped:0 overruns:0 frame:0
TX packets:568404702 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:1036695780 (988.6 MiB) TX bytes:1320211876 (1.2 GiB)
eth0:0 Link encap:Ethernet HWaddr 00:19:99:63:5A:A3
inet addr:88.xxx.xxx.xx9 Bcast:88.208.239.255 Mask:255.255.252.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:14761 errors:0 dropped:0 overruns:0 frame:0
TX packets:14761 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:3011783 (2.8 MiB) TX bytes:3011783 (2.8 MiB)
sit0 Link encap:IPv6-in-IPv4
NOARP MTU:1480 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
[root@server88-xxx-xxx-xx8 ~]#
|