Hello,

I would like to connect a device to pc/104 expansion conector but the problem is that I have not idea how to comunicate my task with this device.

Could somebody give some advice or help or some manual to do it??

Best regards.

Not enough information provided to really provide specific help.
What type of device?
Is it a PC/104 card?
Are you using an off the shelf PC/104 single board computer?

The basic PC/104 bus AFAIK is a nothing more then the PC/AT (i.e ISA). However, the specification does support PCI.

Hello michaelk,

sorry about it.
I am newbie, then some times I have not enought information.

I would like to connect a DPR ( 4K x 16 Dual-Port Static RAM ).
Normally, this device is used to connect processors with different bus speed, as I understand.
My idea is to send data to this device, and in the other side ( other processor ) take data from DPR.


I understand that I need to connect this device to Bus. To make a easy test, I think to connect this device to signal of PC/104, where the bus is present.

I do not if my idea is stupid or not.

Best regards.