PS I am using RHEL 5.3.

Hi
The card I have is a Marvell chipset Netgear wn311T card. Marvell website (www.marvell.com and downloads tab) said it had a driver but after much flaffing aroung I realized the driver it had was 32 bit. The linux driver itself was not good either. So finally I ndiswrapped it.

I then $ndiswrapper -l
yk51x64 : driver installed

GOOD ..... well I run $neat and I don't have my card listed
SO then I go to /etc/sysconfig/network-scripts and copy eth0 to eth1 now am I suppose to fill this out? Is the MAC address the same as the ethernet card? what is the Channel length etc etc????

SO I waste nobodies time unnecessarily, I hereby attach further information:


$iwconfig and get the following:

lo no wireless extensions.

eth0 no wireless extensions.

sit0 no wireless extensions.

Finally I $iwlist wlan0 scan and get the following

wlan0 Interface doesn't support scanning.

$lspci -v I get the following

03:07.0 Ethernet controller: Marvell Technology Group Ltd. 88W8361 [TopDog] 802.
11n Wireless (rev 03)
Subsystem: Netgear Unknown device 7e00
Flags: bus master, 66MHz, medium devsel, latency 32, IRQ 5
Memory at fdde0000 (32-bit, non-prefetchable) [size=64K]
Memory at fddd0000 (32-bit, non-prefetchable) [size=64K]
Capabilities: [40] Power Management version 2

Thanks in Advance

there you go extract the file and run the ./install.sh script

thanks

Is it fedora or linux and which version? I tried the fedora in the past and could not get it to work .. will try and uninstall ndiswrapper and see what happens. please respond if you can

ok I installed teh fedora driver

-rw-r--r-- 1 1000 wheel 57635 Nov 3 15:32 functions
-rw-r--r-- 1 root root 3209 Mar 19 13:11 install.log
-rwxr-xr-x 1 1000 wheel 24876 Nov 3 15:32 install.sh
-rw-r--r-- 1 1000 wheel 13316 Nov 3 15:32 README
-rw-r--r-- 1 1000 wheel 16291 Nov 3 15:32 sk98lin.4
-rw-r--r-- 1 1000 wheel 390453 Nov 3 15:32 sk98lin.tar.bz2
[root@localhost DriverInstall]#

All done. Driver installed and loaded.
To load the module manually, proceed as follows:
Enter "modprobe sk98lin"

Have fun...
[root@localhost DriverInstall]# modprobe sk98lin


Now what. I cannot see my device in neat??? what must I do..Thanks!

What is neat. did you reboot after installing the module. you need to so it will load the device then you need to configure your net work manager to connect.