Hey guys!
I can't get my UMTS card to run at all. As far as I can tell it is being recognized properly and the kernel supports it out-of-the-box and so on, but I can't see anything about in on NetworkManager and the manual procedure using picocom and adressing the device directly gets me only past entering the SIM code. Is there maybe anything I am doing wrong here? :/
Here's a little bit of info about my system:
Lenovo Thinkpad X200
UMTS card: Ericsson F3507g
Arch Linux Stock Kernel 3.12 (I had 3.11 until yesterday, exactly the same problem)
KDE 4.11.3
NetworkManager 0.9.8.8
kdeplasma-applets-plasma-nm 0.9.3.1
modemmanager 1.0.0
Here's some output that might be useful. Bare with me if it's not what you need, I'm a bloody beginner compared to most of you guys.
lspci:
Code:
00:00.0 Host bridge: Intel Corporation Mobile 4 Series Chipset Memory Controller Hub (rev 07)
00:02.0 VGA compatible controller: Intel Corporation Mobile 4 Series Chipset Integrated Graphics Controller (rev 07)
00:02.1 Display controller: Intel Corporation Mobile 4 Series Chipset Integrated Graphics Controller (rev 07)
00:03.0 Communication controller: Intel Corporation Mobile 4 Series Chipset MEI Controller (rev 07)
00:19.0 Ethernet controller: Intel Corporation 82567LF Gigabit Network Connection (rev 03)
00:1a.0 USB controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #4 (rev 03)
00:1a.1 USB controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #5 (rev 03)
00:1a.2 USB controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #6 (rev 03)
00:1a.7 USB controller: Intel Corporation 82801I (ICH9 Family) USB2 EHCI Controller #2 (rev 03)
00:1b.0 Audio device: Intel Corporation 82801I (ICH9 Family) HD Audio Controller (rev 03)
00:1c.0 PCI bridge: Intel Corporation 82801I (ICH9 Family) PCI Express Port 1 (rev 03)
00:1c.1 PCI bridge: Intel Corporation 82801I (ICH9 Family) PCI Express Port 2 (rev 03)
00:1c.3 PCI bridge: Intel Corporation 82801I (ICH9 Family) PCI Express Port 4 (rev 03)
00:1d.0 USB controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #1 (rev 03)
00:1d.1 USB controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #2 (rev 03)
00:1d.2 USB controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controller #3 (rev 03)
00:1d.7 USB controller: Intel Corporation 82801I (ICH9 Family) USB2 EHCI Controller #1 (rev 03)
00:1e.0 PCI bridge: Intel Corporation 82801 Mobile PCI Bridge (rev 93)
00:1f.0 ISA bridge: Intel Corporation ICH9M LPC Interface Controller (rev 03)
00:1f.2 SATA controller: Intel Corporation 82801IBM/IEM (ICH9M/ICH9M-E) 4 port SATA Controller [AHCI mode] (rev 03)
00:1f.3 SMBus: Intel Corporation 82801I (ICH9 Family) SMBus Controller (rev 03)
03:00.0 Network controller: Intel Corporation Ultimate N WiFi Link 5300
lsusb:
Code:
Bus 008 Device 002: ID 0bdb:1900 Ericsson Business Mobile Networks BV F3507g Mobile Broadband Module
Bus 008 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 006 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 005 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 007 Device 002: ID 17ef:480c Lenovo Integrated Webcam
Bus 007 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 001 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
ifconfig
Code:
enp0s25: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
ether f0:de:f1:08:6a:21 txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device interrupt 20 memory 0xf2600000-f2620000
lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 0 (Local Loopback)
RX packets 850 bytes 30331 (29.6 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 850 bytes 30331 (29.6 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
wls1: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 192.168.0.16 netmask 255.255.255.0 broadcast 192.168.0.255
inet6 2a02:8071:2510:b400:221:6aff:febb:aa7a prefixlen 64 scopeid 0x0<global>
inet6 fe80::221:6aff:febb:aa7a prefixlen 64 scopeid 0x20<link>
ether 00:21:6a:bb:aa:7a txqueuelen 1000 (Ethernet)
RX packets 11519 bytes 10882256 (10.3 MiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 7862 bytes 1221541 (1.1 MiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
iwconfig
Code:
enp0s25 no wireless extensions.
wwp0s29f7u4i7 no wireless extensions.
lo no wireless extensions.
wls1 IEEE 802.11abgn ESSID:"Kann ich dein Klo putzen?"
Mode:Managed Frequency:2.412 GHz Access Point: 44:32:C8:30:69:DE
Bit Rate=72.2 Mb/s Tx-Power=14 dBm
Retry long limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=21/70 Signal level=-89 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:2717 Invalid misc:128 Missed beacon:0
Thanks in advance for any help or advice given!
