no USB on FC3 ??
I've just done a fresh install of FC3 w/2.6.11.7 compiled in. Can't get the USB system up for some reason. USB is built-in to the kernel. The system checks my USB hub, registers it, and then disconnects - never to return. At my wits end. Suggestions Please!
DMESG shows -
...
usbcore: registered new driver cdc_acm
drivers/usb/class/cdc-acm.c: v0.23:USB Abstract Control Model driver for USB modems and ISDN adapters
usbcore: registered new driver usblp
drivers/usb/class/usblp.c: v0.13: USB Printer Device Class driver
usbcore: registered new driver hiddev
usbcore: registered new driver usbhid
drivers/usb/input/hid-core.c: v2.0:USB HID core driver
...
ohci_hcd 0000:00:01.2: OHCI Host Controller
ohci_hcd 0000:00:01.2: irq 10, pci mem 0xf3ffe000
ohci_hcd 0000:00:01.2: new USB bus registered, assigned bus number 1
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 3 ports detected
PCI: Found IRQ 10 for device 0000:00:01.3
PCI: Sharing IRQ 10 with 0000:00:01.2
PCI: Sharing IRQ 10 with 0000:00:0b.0
ohci_hcd 0000:00:01.3: OHCI Host Controller
ohci_hcd 0000:00:01.3: irq 10, pci mem 0xf3fff000
ohci_hcd 0000:00:01.3: new USB bus registered, assigned bus number 2
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
usb 2-2: new full speed USB device using ohci_hcd and address 2
hub 2-2:1.0: USB hub found
hub 2-2:1.0: 7 ports detected
ohci_hcd 0000:00:01.2: remove, state 1
usb usb1: USB disconnect, address 1
ohci_hcd 0000:00:01.2: USB bus 1 deregistered
ohci_hcd 0000:00:01.3: remove, state 1
usb usb2: USB disconnect, address 1
usb 2-2: USB disconnect, address 2
ohci_hcd 0000:00:01.3: USB bus 2 deregistered
lspci shows -
00:01.2 USB Controller: Silicon Integrated Systems [SiS] USB 1.0 Controller (rev 07)
00:01.3 USB Controller: Silicon Integrated Systems [SiS] USB 1.0 Controller (rev 07)
Absolutely nothing in /var/log/messages. The doggone thing woked like a champ w/ FC1 under the older 2.4.xx kernel and still works under various live CDs. I don't see any USB mentioned in the lsmod. SCSI and Firewire work fine, too.
|