Ok can't mount Mass Storage device. Using latest Ubuntu 7.10 Computer shows device but reports "Unable to Mount Media"
cat /proc/scsi/scsi =
Attached devices:
Host: scsi1 Channel: 00 Id: 00 Lun: 00
Vendor: HL-DT-ST Model: CD-RW GCE-8483B Rev: 1.04
Type: CD-ROM ANSI SCSI revision: 05
Host: scsi1 Channel: 00 Id: 01 Lun: 00
Vendor: ATA Model: ST34311A Rev: 6.01
Type: Direct-Access ANSI SCSI revision: 05
Host: scsi11 Channel: 00 Id: 00 Lun: 00
Vendor: Samsung Model: Mass Storage Rev: 2.31
Type: Direct-Access ANSI SCSI revision: 02
DMESG=
Code:
[42937.454173] usb 3-2: USB disconnect, address 20
[42937.458288] scsi 10:0:0:0: rejecting I/O to dead device
[42937.458439] scsi 10:0:0:0: [sdb] READ CAPACITY failed
[42937.458443] scsi 10:0:0:0: [sdb] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK,SUGGEST_OK
[42937.458449] scsi 10:0:0:0: [sdb] Sense not available.
[42937.458898] scsi 10:0:0:0: rejecting I/O to dead device
[42937.459036] scsi 10:0:0:0: [sdb] Write Protect is off
[42937.459041] scsi 10:0:0:0: [sdb] Mode Sense: 00 00 00 00
[42937.459044] scsi 10:0:0:0: [sdb] Assuming drive cache: write through
[42937.459444] scsi 10:0:0:0: rejecting I/O to dead device
[42937.463002] scsi 10:0:0:0: rejecting I/O to dead device
[42937.463187] scsi 10:0:0:0: rejecting I/O to dead device
[42937.463728] scsi 10:0:0:0: rejecting I/O to dead device
[42937.463914] scsi 10:0:0:0: rejecting I/O to dead device
[42937.464078] scsi 10:0:0:0: [sdb] READ CAPACITY failed
[42937.464082] scsi 10:0:0:0: [sdb] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK,SUGGEST_OK
[42937.464090] scsi 10:0:0:0: [sdb] Sense not available.
[42937.465046] scsi 10:0:0:0: rejecting I/O to dead device
[42937.465210] scsi 10:0:0:0: [sdb] Write Protect is off
[42937.465215] scsi 10:0:0:0: [sdb] Mode Sense: 00 00 00 00
[42937.465218] scsi 10:0:0:0: [sdb] Assuming drive cache: write through
[42937.468319] scsi 10:0:0:0: rejecting I/O to dead device
[42938.738870] usb 3-2: new full speed USB device using uhci_hcd and address 21
[42938.901732] usb 3-2: configuration #1 chosen from 1 choice
[42938.904706] cdc_acm 3-2:1.0: ttyACM0: USB ACM device
[42939.756321] usb 3-2: USB disconnect, address 21
[43200.387557] usb 3-2: new full speed USB device using uhci_hcd and address 22
[43200.551229] usb 3-2: configuration #1 chosen from 1 choice
[43200.554180] cdc_acm 3-2:1.0: ttyACM0: USB ACM device
[43204.409384] usb 3-2: USB disconnect, address 22
[43205.905564] usb 3-2: new full speed USB device using uhci_hcd and address 23
[43206.072441] usb 3-2: configuration #1 chosen from 1 choice
[43206.075483] scsi11 : SCSI emulation for USB Mass Storage devices
[43206.075727] usb-storage: device found at 23
[43206.075731] usb-storage: waiting for device to settle before scanning
[43211.062021] usb-storage: device scan complete
[43211.065003] scsi 11:0:0:0: Direct-Access Samsung Mass Storage 2.31 PQ: 0 ANSI: 2
[43211.180191] usb 3-2: reset full speed USB device using uhci_hcd and address 23
[43211.447525] usb 3-2: reset full speed USB device using uhci_hcd and address 23
Manually mounting the device reports "is not a block device" and actually, fdisk does not even show a disk...
Code:
Disk /dev/sda: 4327 MB, 4327464960 bytes
255 heads, 63 sectors/track, 526 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Disk identifier: 0x8bc58bc5
Device Boot Start End Blocks Id System
/dev/sda1 * 1 496 3984088+ 83 Linux
/dev/sda2 497 526 240975 5 Extended
/dev/sda5 497 526 240943+ 82 Linux swap / Solaris
I'm a little dizzy chasing all the leads around, I thought maybe someone can troubleshoot this with me and explain these outputs to a nooB.
Sorry if I left anything out...
Thanks in advance