Hello,
I have a problem with my HP ScanJet 5300 on Debian.
With the command sane-find-scanner I found the scanner and also with the scanimage -L.
But when I start the command scanimage -T I get this error message:
scanimage: received signal 2
scanimage: trying to stop scanner
scanimage: scanning image of size 2544x3489 pixels at 24 bits/pixel
scanimage: acquiring RGB frame, 8 bits/sample
scanimage: reading one scanline, 7632 bytes... *FAIL Error: Error during
device I/O
After this I can't never found the scanner with sane-find-scanner and scanimage -L.
Can somebody help me ? I have already "googled" a lot but I haven't found a solution.

In /proc/bus/usb/devices the scanner gives me the following informations:
T: *Bus=03 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= *2 Spd=12 *MxCh= 0
D: *Ver= 1.00 Cls=00(>ifc ) Sub=00 Prot=00 MxPS= 8 #Cfgs= *1
P: *Vendor=03f0 ProdID=0701 Rev= 0.01
S: *Manufacturer=Hewlett Packard
S: *Product=Hewlett Packard ScanJet 5300C/5370C
S: *SerialNumber=0000000000000000
C:* #Ifs= 1 Cfg#= 1 Atr=40 MxPwr=100mA
I: *If#= 0 Alt= 0 #EPs= 3 Cls=00(>ifc ) Sub=00 Prot=00 Driver=(none)
E: *Ad=01(O) Atr=02(Bulk) MxPS= * 8 Ivl=0ms
E: *Ad=82(I) Atr=03(Int.) MxPS= * 8 Ivl=10ms
E: *Ad=83(I) Atr=02(Bulk) MxPS= *64 Ivl=0ms

Hi,

I'm having similar problems. Running XSane or Kooka on Ubuntu and the scanner stops about 20% of the way through the scan. If I peek under the lid the lamp is stopped at the physical end of the original document which is smaller than the full glass size.

Paul in NW Florida