Ok... this is my sixth post so you can yell now..
I`ve gotten as far as adjusting the tool chain,with no problems( after applying some help from this board)now to the problem: this is what i entered:
mv -v /tools/bin/{ld,ld-old}
mv -v /tools/$(gcc -dumpmachine)/bin/{ld,ld-old}
mv -v /tools/bin/{ld-new,ld}
ln -sv /tools/bin/ld /tools/$(gcc -dumpmachine)/bin/ld
and this is the error i got: ln: target '/bin/ld' is not a directory
now being a bit paranoid
i checked each entry 3 times before executing so i know it went in right, so i`m a bit confused why it didn`t. I checked and there is no /tools/bin/ld, but i did find ld in /tools/bin. Is this a typo in the book or have i been whacked with the noob stick again?
never mind, (guess i need to use the search function more often and read the BOOK all the way through)....i believe this is probably my problem :
:
You need the binutils from binutils-pass1 only for Adjusting the tool chain.
"Now that the adjusted linker is installed, you have to remove the Binutils build and source directories." On the same page.
So you need to remove the binutils installed during binutils-pass1 after Adjusting The Toolchain and then reinstall binutils for binutils-pass2...
If that makes sense?
Seriously, you have to read the chapter completely and understand it before doing anything or something may break a few pages (and more importantly hours or days) later.
Tedious and not alwasy the easiest thing to do, I know that, believe me! But once you have done it once... enter ALFS