Hi guys,

I've just installed FC6 on my ASUS W7J laptop and try to setup the network internet connectivity and encountered big problem. Please help me ><

------------------------------------------------------
I have difficult in detecting and install the proper NIC on my linux. Here is the scenario, I have two computers:

(1)Main Computer (WinXP, DSL connected to Internet)
(2)A hub/router (not sure which one), connected to both Main Computer & Laptop using blue ethernet cable
(3)Laptop (WinXP, Fedora Core 6, connected to hub via ethernet cable)

The NIC for the laptop that I've identified (via WinXP MyComputer) is:

Realtek RTL8168/8111 PCI-E Gibabit Ethernet NIC
Location: PCI slot 33 (PCI bus 5, device 0, function 0)
Version: 5.638.1116.2005

However, then I try to add a new device in Network configuration in FC, I can only find Realtek RTL8129 (older version) and I cannot active it (either not supported or because I didn't setup the proper port and I don't know how).

Please help and many many thanks!! ^___^

RMS

useful information here http://gentoo-wiki.com/HARDWARE_RTL8168 essentially you need to r1000 driver loaded, either as part of the default kernel, which apparently is *not* in FC6's kernels, or by recompiling your kernel to add it, or downlaod from realtek.com

http://.../showthread.php?p=2624346#post2624346

or form the links under at the top of the page.

LinuxQuestions.org > Forums > Linux > Linux - Distributions > Fedora
FC6 Ethernet Problem