Reverted to Ubuntu 8.04
Posted 08-20-2009 at 02:43 AM by The Don
My Pc was stolen now I have to resort to using a loan pc with Ubuntu 8.04, I also bought a usb modem(Huawei ec168C) but have problems installing it with usb modeswitch, can anyone help?
Total Comments 1
Comments
-
I found the following way of installing the driver, can anyone please verify if this will work?
*************
Linux Drivers
Instructions for Use:
Steps are as follows (with sample explanation to follow):
* modprobe the usbserial driver directly for the device
* ppp dialer config
How to do it:
Plug in your modem, and then use the 'lsusb' command.
Code
user@linux:~$ lsusb
Bus 002 Device 002: ID 1d09:4000
Bus 002 Device 001: ID 0000:0000
Bus 001 Device 001: ID 0000:0000
Here we get the USB vendor and product ID's (the first one, in this case).
Now we load the 'usbserial' driver specifically for this device:
Code
user@linux:~$ sudo modprobe usbserial vendor=0x1d09 product=0x4000
As you can see, we use the first segment of the ID number as the vendor, and the second segment as the product ID, both with 0x prepended.
Now, we check /dev to see that the devices are there:
Code:
user@linux:~$ ls /dev/ttyU*
/dev/ttyUSB0 /dev/ttyUSB1
Next step is to configure the ppp connection. Since this example is done on an Ubuntu installation, we can use the Debian pppconfig utility
Code:
user@linux:~$ sudo pppconfig
In this utility, you enter the your username, password and the telephone number as needed, and then save the connection. Be sure to pick a descriptive name, as it is what you will be using to dial it up. Exit, and then we're ready to dial.
Dialing on Ubuntu:
Code:
user@linux:~$ sudo pon neotel
Where "neotel" is the connection name you picked in setup.
And that's it. At this point if nothing went wrong, you'll have a fully working ppp0 connection up.
Code:
ifconfig | grep ppp0
*************************
ThanxPosted 08-21-2009 at 05:17 AM by The Don