Cisco PCI 340 - anyone got in working on 8.2?

Hi

I have a new 8.2 installation. System is working fine except for my Cisco
PC4800 - PCI, wireless card:

$ hwinfo

23: PCI 09.0: 0280 Network controller
[Created at pci.65]
Unique ID: WL76.QBjvJtidapA
Hardware Class: network
Model: "AIRONET Wireless PC4800"
Vendor: pci 0x14b9 "AIRONET Wireless Communications"
Device: pci 0x4800 "PC4800"
Revision: 0x01
Memory Range: 0xeffffe80-??? (rw,non-prefetchable)
I/O Ports: 0xcc00-0xcc7f (rw)
I/O Ports: 0xc800-0xc83f (rw)
IRQ: 12 (no events)
Driver Info #0:
Driver Status: aironet4500 is not active
Driver Activation Cmd: "insmod aironet4500"
Config Status: cfg=yes, avail=yes, need=no

When detected by yast2 it suggests to uses the module "aironet4500". I get
no messages in /var/log/messages after commit the changes.

$ ifconfig -a

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:806 errors:0 dropped:0 overruns:0 frame:0
TX packets:806 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:260237 (254.1 Kb) TX bytes:260237 (254.1 Kb)

Trying

$ modprobe aironet4500
modprobe: Can't locate module aironet4500

So I've tried using the module "aironet4500_card" in yast2 and get this:

Apr 18 20:21:15 kiddy kernel: aironet4500.c v0.1 1/1/99 Elmer Joandi,
elmer@ylenurme.ee.
Apr 18 20:21:15 kiddy kernel: aironet4500_cards.c v0.2 Feb 27, 2000 Elmer
Joandi, elmer@ylenurme.ee.
Apr 18 20:21:15 kiddy kernel:
Apr 18 20:21:15 kiddy kernel: <6>AMD756: dev 14b9:4800, router pirq : 1 get
irq : 12
Apr 18 20:21:15 kiddy kernel: PCI: Found IRQ 12 for device 00:09.0
Apr 18 20:21:15 kiddy kernel: eth1: 340 Series 802.11 Direct Sequence found @
0xc800 irq 12 firmwareVersion 1282
Apr 18 20:21:16 kiddy ifup-wireless: command 'iwconfig eth1 mode Managed'
returned
Apr 18 20:21:16 kiddy ifup-wireless: Error for wireless request "Set Mode"
(8B06) :
Apr 18 20:21:16 kiddy ifup-wireless: SET failed on device eth1 ; Operation not
supported.
Apr 18 20:21:16 kiddy ifup-wireless: command 'iwconfig eth1 nick kiddy'
returned
Apr 18 20:21:16 kiddy ifup-wireless: Error for wireless request "Set Nickname"
(8B1C) :
Apr 18 20:21:16 kiddy ifup-wireless: SET failed on device eth1 ; Operation not
supported.
Apr 18 20:21:16 kiddy ifup-wireless: command 'iwconfig eth1 nwid kiddy'
returned
Apr 18 20:21:16 kiddy ifup-wireless: Error for wireless request "Set NWID"
(8B02) :
Apr 18 20:21:16 kiddy ifup-wireless: invalid argument "kiddy".
Apr 18 20:21:16 kiddy ifup-wireless: command 'iwconfig eth1 essid qunfud'
returned
Apr 18 20:21:16 kiddy ifup-wireless: Error for wireless request "Set ESSID"
(8B1A) :
Apr 18 20:21:16 kiddy ifup-wireless: SET failed on device eth1 ; Operation not
supported.
Apr 18 20:21:16 kiddy kernel: long wait with commmand reg busy
Apr 18 20:21:16 kiddy kernel: Command UNKNOWN , result: UNKNOWN, at memblk
1864(RID UNKNOWN) , offset 1764
Apr 18 20:21:16 kiddy kernel: eth1 aironet register dump 1e64 1d64 1c64 7
1a64 1964 1864 1764
Apr 18 20:21:16 kiddy kernel: 101664 1564 1464 1364 1164 f64 e64 c64
Apr 18 20:21:16 kiddy kernel: 20 a64 a64 a64 a64 a64 a64 a64 a64
Apr 18 20:21:16 kiddy kernel: 30 0 0 a64 0 1e64 0 0 1e64
Apr 18 20:21:16 kiddy kernel: 40<3>
Apr 18 20:21:16 kiddy kernel: aironet open failed
Apr 18 20:21:16 kiddy ifup: Cannot enable interface eth1.
Apr 18 20:21:16 kiddy ifup-route: interface eth1 is not up
Apr 18 20:21:24 kiddy /etc/hotplug/net.agent[11642]: No HW description found
... exiting

Which I assume is better?

$ ifconfig -a

eth1 Link encap:Ethernet HWaddr 00:40:96:39:71:71
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:12 Base address:0xc800

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:806 errors:0 dropped:0 overruns:0 frame:0
TX packets:806 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:260237 (254.1 Kb) TX bytes:260237 (254.1 Kb)

# iwconfig
lo no wireless extensions.
sit0 no wireless extensions.
eth0 no wireless extensions.



The card work fine under WinME on the same box. I also have no problems
getting Realtek RTL-8029(AS) network card working.

I've looked around on the internet and this cisco card should be straight
forward to get going. Any ideas on what I can try next?

thanks

Card just needed it firmware updating - had to use windows.