I installed Suse 10.2GM. When I set up the HP 722C printer the drivers were found and I believe it's assigned on /dev/lp0. When I run a test page I get nothing. Everything was fine on Suse 9.3 then I decided to do a clean install of 10.2. I went through YAST printer config and even went to the http://localhost:631/ CUP admin utility successfully...but no working printer. Any ideas on what I've done wrong?

I'm running out of patience with this the Suse 10.2 install but I try a little longer. I don't have my DVD or printer working. At least I have internet.

You can check which device your printer has, by making a hardware check of your system. Then you will be able to use this hardware to good use.