NIC speed problems
Hey,
I have a 3com NIC that Ubuntu 5.10 dectecs just fine that is a 1gigabit NIC. When I do a sudo ethtool eth0 i get this information. Supported ports: [ TP ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Advertised auto-negotiation: Yes Speed: 10Mb/s Duplex: Full Port: Twisted Pair PHYAD: 0 Transceiver: internal Auto-negotiation: off Supports Wake-on: g Wake-on: d Current message level: 0x00000037 (55) Link detected: yes I can set it to 100mb/s full duplex and its fine but when I set it to 1000mb/s it doesn't communicate with the network at alL???? any help would be greatly appricated as I would like to use the nic to its full potentinal. |
1st obvious question: Is the rest of the network 1 gigabit too? Do you have other PCs on the network which are using 1Gb?
|
Yes, the system and a few other systems are all on a gigabit switch with gigabit nics.
|
Can you post the results of sudo ethtool eth0 when the card is set to 1Gb?
|
Hey, here is the ethtool eth0 when it is set to 1000mb/s
Supported ports: [ TP ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Advertised auto-negotiation: Yes Speed: 1000Mb/s Duplex: Full Port: Twisted Pair PHYAD: 0 Transceiver: internal Auto-negotiation: off Supports Wake-on: g Wake-on: d Current message level: 0x00000037 (55) Link detected: yes Once its set to 1000mb/s the nic no longer talks to the network. Its as if the system is unplugged from the network. It is also plugged into the gigabit switch and has the proper cat5 for a gigabit network. |
All times are GMT -5. The time now is 06:32 PM. |