Hey all,

I installed SUSE 9.2 without any problems, everything works fine. I open Yast to install Apache, I fill out the Http server configuration page, click finish. It then takes me to the Saving HTTP Server Config page, it "writes the apache2 settings" but then it tries to "run SuSEconfig" and I get an error saying "Cnnot adjust 'apache2' service.

can someone help me with this??

Thanks a lot!

Mike

well, there were a couple of updates that I didn't see before.. one's for apache... it's installing right now so maybe the problem will be fixed... I'll let you know

ugh... the updates didn't change a thing... can anyone help with this please? I really want to have it completely set up before tomorrow night...

have u tried to start the server?
/etc/init.d/apache2 start

probably it will work fine...or give u a detailed explanation in the error log whtas wrong with your apache configuration.
the Suse sysconfig files are sort of tricky...i never understood them yet

good luck,
j.

alright,

I ran it in the Konsole and it gave me a couple errors in the syntax of the loadmodule.conf... I tried installing it in Yast again, but this time I disabled the problematic modules... and it worked!

thanks a lot for the help!

Suse config will give an error if your configuration settings have some wrong entries or may be documents directory may not be correct. Just check that.

could someone help me suse 9.2 i still can't get wireless to work rt2500 chipset linux:/home/kikid # iwconfig
lo no wireless extensions.

sit0 no wireless extensions.

wlan0 IEEE 802.11g ESSIDff/any Nickname:"linux"
Mode:Auto Frequency:2.412 GHz Access Point: 00:00:00:00:00:00
Bit Rate=54 Mb/s Tx-Power:20 dBm Sensitivity=-120 dBm
RTS thr=2347 B Fragment thr=2346 B
Encryption keyff
Power Managementff
Link Quality:100/100 Signal level:136/154 Noise level:0/154
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:188 Missed beacon:0