LinuxQuestions.org
Visit Jeremy's Blog.
Home Forums Tutorials Articles Register
Go Back   LinuxQuestions.org > Forums > Linux Forums > Linux - Distributions > SUSE / openSUSE
User Name
Password
SUSE / openSUSE This Forum is for the discussion of Suse Linux.

Notices


Reply
  Search this Thread
Old 06-16-2006, 01:25 PM   #1
BACTRATE
Member
 
Registered: Jan 2004
Location: NORTH WEST UK
Posts: 180

Rep: Reputation: 30
Suse 10 kernal update problem


I have just installed the latest security patches and kernal update and i now cannot connect to the internet.I use a eagle usb modem and have reconfigured the modem .It now loads up ok but and says it is connected but for all requested url's I get not available.
Greatful for any help

Dave
 
Old 06-17-2006, 09:35 AM   #2
hal8000b
Member
 
Registered: Mar 2001
Location: UK
Distribution: Mint, Arch, Debian7
Posts: 194

Rep: Reputation: 23
Quote:
Originally Posted by BACTRATE
I have just installed the latest security patches and kernal update and i now cannot connect to the internet.I use a eagle usb modem and have reconfigured the modem .It now loads up ok but and says it is connected but for all requested url's I get not available.
Greatful for any help

Dave

I may be wrong but kernel updates dont normally require you to reinstall your modem. You do
however have to recompile any modules that were added to your original kernel, i.e. Nvidia or ATI drivers.

To help solve your problem ypu need to provide a little more information. Are you using kinternet or kppp to connect and send your password. Usually there is some kind of connect script with a usb modem, either this has failed, or you have incorrect settings for your DNS servers etc.

Check your settings again, also monitor the output of dmesg and check the contents of /etc/resolv.conf for your DNS settings.
Presumably some microcode has to be loaded for an eagle usb modem?
You are getting a connected message (from what ? kppp ?) Open a terminal
and type
ip addr
ifconfig
ping www.google.com
ip route

Hopefully there may be enough error messages that someone can help further
 
Old 06-17-2006, 12:20 PM   #3
BACTRATE
Member
 
Registered: Jan 2004
Location: NORTH WEST UK
Posts: 180

Original Poster
Rep: Reputation: 30
Thanks hal8000b

Thanks for the info i will give it my best.

Regards

Dave
 
Old 06-17-2006, 01:02 PM   #4
BACTRATE
Member
 
Registered: Jan 2004
Location: NORTH WEST UK
Posts: 180

Original Poster
Rep: Reputation: 30
Kernal update internet connect problem extra info

I have run ip addr and ipconfig etc and get the following-

linux:/home/david # eaglectrl -d
CMVs successfully sent to driver.
Options successfully sent to driver.
Using DSP code for POTS line
DSP code successfully loaded.
linux:/home/david # startadsl
linux:/home/david # ip addr
1: lo: <LOOPBACK,UP> mtu 16436 qdisc noqueue
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:0
0:00
inet 127.0.0.1/8 scope host lo
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: sit0: <NOARP> mtu 1480 qdisc noop
link/sit 0.0.0.0 brd 0.0.0.0
3: eth0: <NO-CARRIER,BROADCAST,MULTICAST,NOTRAILERS,U P> mtu 1500 qdisc pfifo_fast qlen 1000
link/ether 00:15:f2:00:57:77 brd ff:ff:ff:ff:ff:f f
inet6 fe80::215:f2ff:fe00:5777/64 scope link
valid_lft forever preferred_lft forever
4: eth1: <BROADCAST,MULTICAST,UP> mtu 65535 qdisc pfi fo_fast qlen 1000
link/ether 00:60:4c:72:8a:27 brd ff:ff:ff:ff:ff:f f
inet6 fe80::260:4cff:fe72:8a27/64 scope link
valid_lft forever preferred_lft forever
7: ppp0: <POINTOPOINT,MULTICAST,NOARP> mtu 1492 qdisc noop qlen 3
link/ppp
linux:/home/david # ipconfig
bash: ipconfig: command not found
linux:/home/david # ifconfig
eth0 Link encap:Ethernet HWaddr 00:15:F2:00:57:77
inet6 addr: fe80::215:f2ff:fe00:5777/64 Scope:Link
UP BROADCAST NOTRAILERS MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:5 Base address:0xc000

eth1 Link encap:Ethernet HWaddr 00:60:4C:72:8A:27
inet6 addr: fe80::260:4cff:fe72:8a27/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:65535 Metric:1
RX packets:80 errors:0 dropped:0 overruns:0 frame:0
TX packets:95 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1100 (1.0 Kb) TX bytes:3718 (3.6 Kb)

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:116 errors:0 dropped:0 overruns:0 frame:0
TX packets:116 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:8780 (8.5 Kb) TX bytes:8780 (8.5 Kb)

linux:/home/david # ping www.google.com
ping: unknown host www.google.com
linux:/home/david #


Thanks

Dave
 
  


Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off



Similar Threads
Thread Thread Starter Forum Replies Last Post
Newbie: SUSE Linux 10 kernal update requires running lilo before boot Catheryn Smoll Linux - Kernel 1 04-26-2006 06:03 PM
X wont start after update/Nvidia kernal/module problem Evok3 Linux - Newbie 2 04-15-2006 01:32 PM
Kernal Update canuck_barlow SUSE / openSUSE 2 03-30-2005 12:42 PM
Where can i get a kernal update RPM RancidWannaRiot Mandriva 2 12-05-2003 05:08 PM
kernal update 2.2 to 2.6 dandysf Linux - Newbie 0 08-21-2003 11:41 AM

LinuxQuestions.org > Forums > Linux Forums > Linux - Distributions > SUSE / openSUSE

All times are GMT -5. The time now is 11:07 AM.

Main Menu
Advertisement
My LQ
Write for LQ
LinuxQuestions.org is looking for people interested in writing Editorials, Articles, Reviews, and more. If you'd like to contribute content, let us know.
Main Menu
Syndicate
RSS1  Latest Threads
RSS1  LQ News
Twitter: @linuxquestions
Open Source Consulting | Domain Registration