SATA II on Slackware 11?
Hello,
i have a plan doing installation with SATA II in slackware 11, dees Hard drive SATA II 300 detected automatic during installation on default slackware 11 ISO,is it using kernel sata.i during booting ? because i had bad experience using slackware 10.1 where it cant detected SATA during booting... and i searching the forum it said, it must recompiling kernel... wew thanks in advance b4 |
sata on Slack11
I see in the changelogs that sata should be supported:
a/kernel-ide-2.4.33.3-i486-1.tgz: Upgraded to Linux 2.4.33.3 sata.i kernel. I have seen some other threads where partition might be /dev/sdaX instead of old way /dev/hdaX when using the new sata modules. So if you were upgrading kernel and modules you might have to modify your lilo and fstab, but I would imagine that a clean install from scratch should set those things correctly. Try it and if you hit a snag, post back. HTH, bbeers |
All times are GMT -5. The time now is 07:24 AM. |