Hi

i've installed the last release of slackware 10.2 on a server with

2 scsi IBM ultra 320 disk configured in RAID 1 with the bios utility

then i've made 3 partitions, /dev/sda1 /dev/sda2 /dev/sda3

i will recompile the last stable kernel,

i have encluded all in device driver->scsi->low level as built in but i still get a kernel panic when the system try to mount /dev/sda2 on /

obviusly i've compiled all, recompiled lilo, ecc ecc

when i've installed slackware i've used image raid.s

can you help me? thanks

here there are the specific controller from the site producer:
Ultra320 SCSI

LSI Logic* 53C1030 Dual-Channel; two Ultra320/LVD channels (connected via two internal 68-pin-wide connectors); maximum data transfer 320 MB/sec on each Ultra320/LVD channel; supporting entry-level RAID functionality (LSI Logic Integrated Mirroring* and Integrated Striping*).

Integrated RAID

Integrated Intel® RAID controller based on the onboard Intel IOP332 processor, resident firmware, and drivers when enabled via optional Intel RAID Activation Key and RAID memory and supporting RAID 0, 1, 5, 10, and 50; support for the Intel® Portable Cache Module, which provides battery backup of RAID cache.

i've fixed the problem enabling

"Device Drivers"
"Fusion MPT device drivers"
"Fusion MPT ScsiHost drivers for SPI"

in the kernel...

You shouldn't have had to do this. In earlier kernels, LSI is under a different company name in low level drivers. I had to figure that out the hard way.