LinuxQuestions.org - Alsa, emu10k1 and flash

I use the CVS version of alsa, so maybe my installation is different. My file:
Code:
# Set your card type on the next line so that loading the

# kernel module works correctly.

#

# Accepted values are 'emu' and 'audigy'

#  use 'audigy' if you have an audigy based sound card,

#  otherwise use 'emu'

#

# Note: you should only have to set this if:

#    (1) the auto-detect script fails

#        - no lspci support

#        - no /proc/pci support

#        - the kernel just plain doesn't like you

#    (2) you like to set everything

CARD_TYPE="audigy"



##

## This file is used to configure emu10k1's emu-script

##



CARD_IS_5_1=no

USE_DIGITAL_OUTPUT=no

ENABLE_TONE_CONTROL=yes



# Note, it's safe to say yes to the next option even if you're not going

# to use it. When this option is enabled, the driver can autodetects AC3

# data and behaves normally with normal audio.

# (Saying yes causes some of the soundcard's resourses to be used up)

AC3PASSTHROUGH=yes



# Change this to yes to enable the Livedrive midi port and IR remote

# control.

ENABLE_LIVEDRIVE_IR=no



# Most Lives have their analog front signals inverted. If you have

# problems with your setup (low bass), try changing this to 'yes'. (This

# option has no effect with digital setups)

INVERT_REAR=no



#Multichannel playback (for 4 - 6 channel setups)

MULTICHANNEL=yes



# On 5.1 cards in multichannel mode, should the multichannel data be fed

# to the sub as well?  You probably don't want this if you have a

# speaker set like the DTT2200 which already feeds all channels to the

# sub in hardware.

ROUTE_ALL_TO_SUB=no



# By default, the front analog channels have a +12dB boost applied to

# them by the AC'97 mixer. If you encounter clipping, or find that the

# volume of the front speakers is too high in a multichannel setup, try

# changing this to 'no'.

ANALOG_FRONT_BOOST=yes







# Surround

##################



# Some wavs, or mp3 are surround sound encoded the next two

# options can be used to decode these in hardware.

# (select on or the other, not both)



# passive matrix surround decoder

SURROUND=yes



# Active matrix surround decoder

PROLOGIC=no





# Extra Inputs

#################



## This connector is mounted on the card itself

ENABLE_CD_Spdif=yes  # Volume control is 'Digital1' in aumix/gmix/kmix



# The next four inputs are found on Livedrives, some of these may also

# be inputs on the older add-on daughter cards.



ENABLE_OPTICAL_SPDIF=no # Volume control is 'Digital2'

ENABLE_LINE2_MIC2=no    # Volume control is 'Line2'

ENABLE_RCA_SPDIF=no    # Volume control is 'Digital3'

ENABLE_RCA_AUX=no        # Volume control is 'line3'